Vulcan-Hart service manual Power ON/OFF Switch, Indicator Light, Thermostat

Page 6

POWER ON/OFF SWITCH

WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.

1.Remove the control panel.

2.Label and disconnect the wires to the power ON/OFF switch.

3.Squeeze the switch retainer and slide the switch out through the front of the control panel.

ON/OFF

Switch

Figure E

4.Reverse procedures to install and check for proper operation.

INDICATOR LIGHT

WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.

1.Remove the control panel.

2.Label and disconnect the wires to the Red indicator light.

3.Squeeze the light retainers and slide the indicator light out through the front of the control panel.

4.Reverse procedures to install and check for proper operation.

THERMOSTAT

WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOW LOCKOUT / TAGOUT PROCEDURES.

1.Remove the control panel.

2.Remove the knob.

3.Remove the two screws and two washers securing the thermostat and thermostat dial to the control panel, then remove the thermostat and thermostat dial.

4.When installing a new thermostat reverse the procedure and be sure to position the thermostat dial with OFF at the top.

5.Check calibration. Refer to the Service Procedures and Adjustments section of this manual.

F35628 (10-04)

— 6 —

Image 6
Contents 900RE Series Heavy Duty GAS Griddles Table of Contents Introduction Installation Operation Cleaning SpecificationsGeneral ToolsRemoval and Replacement of Parts Component LocationControl Panel Covers and PanelsPower ON/OFF Switch Indicator LightThermostat Flame Switch Ignitor ModuleGAS Burner Pilot SolenoidPilot Dual SolenoidService Procedures and Adjustments Main Burner AdjustmentThermostat Calibration GAS Pressure Measurement Pressure Readings in W.CElectrical Operation Component Description Sequence of OperationSchematic Diagrams Schematic Drawing for 36 Griddle Schematic Drawing for 48 Griddle Schematic Drawing for 60 Griddle Schematic Drawing for 72 Griddle Troubleshooting Guide Symptom Cause RemedyTroubleshooting Guide Form 35628