Fault codes
You are reminded that if you call a Fisher & Paykel Authorised Service Centre because of a User Fault, it is not covered by the Warranty. Should you encounter any problems we recommend that you call our Customer Care Centre.
920 model only
In the 920 Dishwasher, the Time Remaining Display informs you when there is a fault.
The fault codes are as follows and we recommend that you check the chart below and correct if possible. If the fault code cannot be removed by pressing the POWER button, turn the power off at the mains supply, correct the problem if possible and turn the Dishwasher on again. If the fault code still appears, call your Fisher & Paykel Dealer or Authorised Service Centre.
Code | Description | Possible cause | What to do |
U1 | Dishwasher | Water tap not turned on. | Turn the water tap on. |
| attempted to fill to |
|
|
| Too much foam. | See ‘Problem solving’ section. | |
| correct level but | ||
|
|
| |
| Wash pump faulty. | Call your Fisher & Paykel Dealer | |
| failed. | ||
|
| or Authorised Service Centre. | |
|
|
| |
|
|
|
|
|
| Dishwasher not draining. | See ‘Problem solving’ section. |
|
|
|
|
F1 | Flood switch has | Flood has occurred. | Turn the power and water |
| been activated. |
| supply off to the dishwasher. |
|
|
| Call your Fisher & Paykel Dealer |
|
|
| or Authorised Service Centre. |
F3 | Temperature fault. | Incoming water too hot. | Decrease the incoming water |
|
|
| temperature to the dishwasher. |
|
|
|
|
| Water temperature. | Faulty temperature | Call your Fisher & Paykel Dealer |
|
| sensor. | or Authorised Service Centre. |
|
|
|
|
| Overheating. | Faulty element. | Call your Fisher & Paykel Dealer |
|
|
| or Authorised Service Centre. |
|
|
|
|
F4 | No increase in water | Faulty element. | Call your Fisher & Paykel Dealer |
| temperature during |
| or Authorised Service Centre. |
| wash cycle. |
|
|
| Electronics controller | Call your Fisher & Paykel Dealer | |
|
| ||
|
| faulty. | or Authorised Service Centre. |
|
|
|
|
|
| Faulty temperature | Call your Fisher & Paykel Dealer |
|
| sensor. | or Authorised Service Centre. |
820 model only
In the unfortunate event of a fault occurring, the Dishwasher will continuously beep every second. If the continuous beeps cannot be removed by pressing the POWER button, turn the Power off at the mains supply, wait 10 seconds, and turn the Dishwasher on again. If the continuous beeps still occur, call your Fisher & Paykel Dealer or Authorised Service Centre.
22
