Fisher and Paykel Nautilus Dishwasher Installation Manual

INSTALLATION INSTRUCTIONS

Depth (C) 560mm

Height (A) 825-875mm

Width (B) 600mm

Door open (D) 595mm

Electrical

A 3 Pin 10 Amp switched outlet is required. The switch must be located in a readily accessible position with the product installed.

Note

Ensure underside of bench is sealed with an oil based paint or moisture-proof polyurethane to prevent possible steam damage.

Height	825-875mm
Width	595mm
Depth	555mm
Electrical	230-240 vAC
Drying	Residual Heat / 1500 Watt Element
Water Pressure	Minimum 30 kPa (4.3 psi)
	Maximum 960 kPa (140 psi)
Water Temperature	Cold water recommended.
	Hot ideally 60-65°C (must not exceed 75°C)
Place Setting	12

Image 6

Contents

Dishwasher Page Contents Installation instructions Before you startPlumbing Built-In Installation InstallationTo Change the Setup for a hot or cold water supply Levelling Electrical Joinery dimensions DW820 & DW920Specifications Product Size Diagram 1 Dishwasher Diagram 2 Dishwasher & waste disposal unitPlumbing and drainage options Introduction AccessoriesSafety instructions First use Quick operating instructions START/PAUSE button Power ButtonControl panel Off Wash button Eco button Time remaining display 920 Model Only Loading the dishwasher Upper basketLower basket Cutlery basket Detergent Detergent usageFilling the detergent dispenser Drying Rinse aidHow much rinse aid? To fill the dispenser Wash programmes Changing the pre-set options End of programme beeps Australian/New Zealand standards AS2007.1 Loading patternsDetergent quantities Care guide Cleaning the dishwasher Care and cleaningCleaning the strainer Cleaning the spray arms Problem solving Problem Possible cause What to do Water spots, streaks or Fault codes Model only Manufacturer’s warranty This warranty does not coverFisher & Paykel undertakes to New Zealand If you need assistance If you need serviceCustomer care Australia If you need assistance callPage Suburb Product detailsModel/Serial No Country