Sears 36519, 36511 owner manual Preparation, Level, Electrical Connections, GAS Connections

PREPARATION

1.Remove all tape and packaging.

2.Take the accessory pack out of the oven.

3.Check to be sure that no range parts have come loose during shipping.

4.Lift the cooktop and remove the four shipping screws from the cooktop burner. These screws may be discarded.

'it'<'-----SHIPPING SCREW

I

LEVEL

For proper baking results, the range must be leveled. The height of the range must also be adjusted to the height of the counter, To do this:

1.Use a 1 3/8" open end or adjustable wrench to equally back out the four leg levelers until the flanges (rims)

below the sides of the maintop are above the top of the counter.

2.Install the oven racks in the oven (see the Cleaning and Care section in the manual for instructions for additional information).

3.Place the range where it will be installed, then put a spirit level, or a glass measuring cup partially filled with water, on one of the oven racks to check for levelness. It using a spirit level, take two readings with the level placed diagonally first in one direction and then the other.

4.Usethewrenchtoadjusttheleglevelers. Youmayhave to pull the range away from the wall to reach the rear leg levelers. The range should rest on the floor and not hang from the counter.

SPIRIT

LEVEL

ELECTRICAL CONNECTIONS

Check with your local utilities torelectrical codes which apply in your area. It there are no local codes, the National Electrical Code, ANSI/NFPA No. 70-1990 must be followed. You can get a copy by writing:

National Fire Protection Association

Batterymarch Park

Quincy, MA 02269

An adequate electrical supply and outlet must be used to operate the electrical parts of your range.

The range cord has a three prong plug and must be used with a properly grounded three hole outlet with a standard 120 volt 60 hertz AC household current. Improper grounding can affect ignition on spark ignition models.

The preferred method of electrical hook-up is shown in Fig.

8.If you do not have a grounded (three hole) outlet, have a qualified electrician change your old outlet or install a new one.

A grounding adapter plug may be used to convert a two hole outlet to a three hole outlet until the grounded outlet can be installed. (See Fig. 9). This should be done onlytemporarily and only it the two hole outlet is properly polarized.

Do not under any circumstances cut or remove the grounding pro ng from the range cord. Failure to provide proper polarization may cause shock and fire hazard.

PLUG WITH GROUND PRONG POLARIZED RECEPTACLE

PROPERLY POLARIZED AND PROPERLY GROUNDED GROUNDED RECEPTACLE

i_METALEYELET GROUND

	RECEPTACLE		_
L	PL.ATE		_"
	MOUNTING		Ilil
	SCREW .		._//_/_
Fig. 8	Fig.	9
PREFERRED METHOD	TEMPORARY	METHOD

GAS CONNECTIONS

Call your gas supplier and ask which codes apply in your area. If there are no codes, you must follow the NATIONAL FUEL GAS CODE, ANSI/Z223.1-1988. You can get a copy by writing:

American Gas Association

1515 Wilson Boulevard

Arlington (Rosslyn), VA 22209

It you are installing the range in a mobile home you must followthe MANUFACTURED HOME CONSTRUCTION AND

SAFETY STANDARD, TITLE 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and

Safety, Title 24, HUD Part 280). If this standard does not apply, you must follow the STANDARD FOR MANUFAC- TURED HOME INSTALLATIONS 1982 (Manufactured Home Sites, Communities and Set-Ups), ANSI A225. 1-1984 or local codes. You can get a copy of the Standards by writing:

Office of Mobile Home	Standards
HUD Building
451 7th Street,	S.W.
Washington, D.C.	20410	GINS1Ol