Sears 36511, 36519 Removable Oven Door, Removable Oven Racks, Removable Oven Bottom, To remove

Page 25

REMOVABLE

OVEN DOOR

 

To remove:

 

STOP (BROIL)

POSITION

 

 

1. Open the doer to the stop position {see illustration).

 

2. Grasp the door at each side and lift up and off the hinges.

/

NOTE: When the door is removed and hinge arms are at

stop position, do not bump or try to move the hinge arms.

The hinges could

snap back causing an injury to the

hands or damage to the porcelain on the front of the

 

range. Cover the hinges with toweling or empty towel

 

rolls while working in the oven area,

 

To replace:

 

 

 

1. Hold the door over the hinges with the slots at the bottom

 

edge of the door lined upwith the hinges. The hinge arms

HINGE

must still be in the stop

position.

2. Slide the door down onto the hinges as tar as it will go and

 

close the door.

 

 

 

REMOVABLE

OVEN

RACKS

 

Be careful not to scratch the oven finish when installing or removing oven racks.

To install:

1.Set the raised back edge of the rack on a pair of rack guides.

2.Push the rack in until you reach the bump in the rack guide, then lift the front of the rack a bit and push the rack all the way in.

TO remove:

1. Pull the oven rack out, then up.

Some models have one standard oven rack and one folding oven rack.

The folding rack can be conveniently stored away when not in use.

REMOVABLE OVEN BOTTOM

The oven bottom may be removed for cleaning heavy spill- overs or to reach the oven burner.

Be careful not to scratch the oven finish when removing or replacing the oven bottom.

To remove:

1.Slide the tab at the center front of the oven bottom to the left.

2.Lift the oven bottom up and out.

To replace:

1.Slip the oven bottom into the oven so the tabs in the rear of the oven bottom fit into the slots in the oven back.

2.Lower the tront of the oven bottom into place and slide the tab at the front right to lock the oven bottom into place.

24

GMNT06 1

Image 25 Contents
Sears Contents Burner Adjustments For Your SafetyLocation Tool ListPreparing the Counter If you are using the FillerControl Panel END Caps Side Trim Extension KITLevel PreparationElectrical Connections GAS ConnectionsFlexible Connector HOOK-UP Never reuse an old connector when installing a new rangeTo Check for Leaks Rigid Pipe HOOK-UP from Floor or WallAdjust Burner Orifices Adjust Pressure RegulatorCAP Spring NAT Retainer Adjust Air Shutters Making Burner AdjustmentsTo adjust air shutters AIR Shutter SHUT-OFFVALVE Open PositionFig. A9 Step Adjust Orifice HoodsExcess slack in the chain could allow the range to Installation InstructionsGAS Range Stability Device Important Instructions for Your Safety Always use care when opening oven door. Let hot air Important Safety NoticeKeep this book for later use Your Range Turn to set Function ButtonsBurner Ignition CooktopOven Vent 12,000 BTU BurnerTo Bake or Roast To USE the TimerAutomatic Oven OFF Recalling FunctionsCake layers Oven CookingRack Position Total Time Food = Highest Minutes = Lowest LO Broil10-12 Well DoneAfter a Clean Cycle Before a Clean CycleNeed to be repeated To SET SELF-CLEAN Cycle Self-cleaning oven finish Part Cleaning Materials RemarksBrushed chrome cooktop Glass oven door/windowGlass PartGlass Collar Bulbcover To remove burners LIFT-UP CooktopTo replace burners Removable Oven Racks Removable Oven DoorRemovable Oven Bottom To removeDontcall for Service Until YOU Check ProblemPossible Cause To Adjust Oven Temperature Adjusting Oven TemperatureHOW to Order Repair Parts 801 601 63805 Number Parts List for Main TOP Section234 256 258 259 861 221 220 233 601 936 235 215 231807 293 226560 570 580 Illustration and Parts List for Wire Harnesses and Options166 173 946 183314 302 986 838 366 307 352801 374303 819 320Parts List for Broiler and Oven Burner Section KEY Kenmore 30 SELF-CLEANING GAS RANGE-MODEL Number911.3651190 Optional Rear Main Topfiller812 131 124143 @ g2 Lain ENAMELs Painted or Bright Metal Full 90..DAY Warranty on Mechanical AdjustmentsFinished Parts Sold by SEARS, Roebuck and CO., Chicago, IL