Importantinstructionsfor Yoursafety

Tools you will need:

Phillips head screwdriver

1 3/8" open end or adjustable wrench

1.Remove the bracket from the prepack located inside the oven.

2, Decidewhetherthebracketwillbeinstalled

on the right or left side of range location.

3, ff the bracket side of the range is adjacent

to a cabinet, place the bracket against back wall and cabinet as shown below.

	ADJACENT CABINET OR FINAL
	LOCATION OF RANGE SIDE	OUTS_OEEDGE OF
	PANEL	OUTS_OEEDGE OF
	PANEL	TO BE
		TO BE
		FLUSH WITH LEFT OR
		RIGHT SlOE OF RANGE
		\
		WALL BEHIND
		RANGE1

If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the bracket with its outside edge at this location and against back wall. See illustration below.

o Determine whether you will anchor the bracket to the floor or wall. Make sure this

location is clear of electrical wiring or plumbing.

5.Fasten the bracket securely with the screws

provided. Screws are self-drilling in wood, plywood, particle and chip board, and

most metal framing. If attaching to masonry, you can buy suitable screws and

anchorsathardwarestores. Useamasonry drill to drill the required holes.

	BRACKET	WALL
	\	WALL
	\	PLATE

SCREW MUST ENTER _k	/
SCREW MUST ENTER _k
WOOD OR METAL

ATTACHMENT TO WALL

6.Using the wrench, back out the four leg levelers at least two turns. See your

installation guide for more leveling information before positioning range.

7.Slide the range in to place. Be sure rear leg

levelerfuIlyengagestheslotinthebracket. If

range cannot be moved back far enough for rear leg leveler to enter bracket, move

bracket forward as required and attach to floor in new location.