Changing the door hinging

The appliance is supplied right hand hinged. If left hand door hinging is required, follow the instructions below.

Removing the door handle:

^Remove the cover caps from the opposite side, and fit them into the empty holes.

Changing over the door:

First the side section of the handle must be removed:

^Pull door handle a towards you. Side section b slides back, creating a gap d between side section b and mounting plate c.

^Place a suitable object (e.g. a spoon handle) in gap d, and slowly lever the handle towards the door.

Be careful not to let the "spoon handle" slip, causing damage to the appliance.

The side section b can now be removed.

^Pull side section b out of the guides on the mounting plate.

^Loosen the 4 screws (Torx 15) in the mounting plate, and remove the handle.

^Close the appliance door, unscrew hinge bracket a, and take the door off.

^Take hinge pin b out of the hinge bracket, then refit it in the second hole of the hinge bracket. (Use the spanner supplied to unscrew and refit the hinge pin).

^Use the spanner supplied to unscrew upper hinge pin c, and refit it on the other side.

^Remove stoppers d, and unscrew bracket e . Refit the bracket and stoppers on the other side of the door.