Source Setup with CAS-RC Remote Control

INSTALLER

CAS-RC Remote Control

The CAS44 controller does not require programming for the controller or for source setup. All source setup and control is contained in the CAS-RC remote control.

The CAS-RC Remote Control is designed for use with the Russound CAS44 controller amplifier and system keypads (KP4 and KPL). It is designed to operate source devices and the audio system keypad, and is preprogrammed to control Russound components ST2 Tuner and SMS3 Media Server. The CAS-RC controls up to four devices.

Features and Functions

Note: S1, S2, S3, S4, Vol +/-, Mute and Power are system commands and are the same for any source. All other buttons are dependent upon the device code associated with the source and may vary from device to device.

The following Key Charts provide a general description of button functions.

Key Charts

Select a device. These keys are preset for Russound devices, but can be re-programmed (see “Programming a Device”).

S1= Russound Tuner 1

S2= Russound Tuner 2

S3= Russound SMS3 Stream 1

S4= Russound SMS3 Stream 2

Turn the selected zone on or off.

Program sequences.

Select next/previous.

Select the next/previous chapter on some models of DVD players.

Press LAST to recall the last-viewed channel.

Raise or lower the sound level.

Press MUTE to turn the sound off or on.

Move the cursor in the menu screens.

Press OK to choose the high-lighted menu option.

Performs “Enter” function for devices.

Press Enter to choose the high-lighted menu option.

Performs “OK” function for devices.

Skip backward, rewind, fast forward, skip forward, stop pause, or play tracks on disc.

Use Page Up/Down with cable or satellite boxes.

Note: May have to learn in these functions.

View the current channel and program information.

Display the menu for the selected device.

Exit the selected device’s menu, guide, or program without making a menu selection.

Display the program guide for the selected device.

Change inputs on selected device.

To change inputs on CAS44 use

S1 - S4 buttons.

Press LAST once to recall the last channel and to page back one screen in the main menu.

Directly enter channels (e.g., 09 or 31). Press OK to send channel number entries on some TV models.

Programming a Device

Note: S1, S2, S3, S4, Vol +/-, Mute and Power are system com- mands and are the same for any source. All other buttons are depend- ent upon the device code associated with the source.

Before proceeding, find the codes for the devices you want to pro- gram in, under “Manufacturer’s Codes” in this manual. To control Universal TV, VCR or DVD, Cable or Satellite Receivers, Amplifier or Tuner, and Auxiliary devices, follow these steps.

1.Turn on the device (e.g., DVD player) and if needed, load media.

2.Press a device key (S1, S2, S3 or S4).

3.Press and hold SET until the red LED blinks twice, then release.

4.Enter the first five-digit code for your device.The LED blinks once as each digit is entered. If the code is valid, the LED blinks twice. Note: If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.

5.Aim the remote at the device and press a function button. The