Keypad Rear Panel and Installation

INSTALLER

COMPONENT GUIDE

CAT-5 to KP4/KPL Connection

The KP4/KPL keypad uses a 110- punchdown terminal on the back panel to provide simple installation and a strong connection for CAT-5 cable’s eight conductors. Punchdown terminals require the use of a punchdown tool. Attach the CAT-5 cable to the 110-punchdown terminal on the KP4 keypad as shown, matching the conductor col- ors to the connection color guide. The keypad will not operate properly

if the terminations deviate from the required connection order. Take care when using an impact 110 punchdown tool, as this may overspread the con- tact points. Use of the impact tool may propel stray bits of wire and jack- et into the keypad’s chassis and possi- bly cause a short in the circuitry. Gently shake or blow air through the keypad chassis to remove stray wire before the keypad is installed into the junction box.

Source Label Installation

Note: Source labels must be inserted prior to installing the trim plate on the keypad.

1.Determine the system’s source names and numbers (e.g., CD, Source 1).

2.Select the corresponding source name label from the includ- ed label sheets. Left-side labels are used for sources 1, 3 and 5; right-side labels are used for sources 2, 4 and 6.

3.Slide the label into the window slot until the source name is centered in the window.

KP6/KP4 Source Labels

Keypad Installation

1. Ensure it is possible to route the wire to the location you have chosen.

2. To install a single-gang keypad, you will need to use	Electrical
a UL/CSA approved plastic single-gang (18 ci) electrical	Box
box.
3. Route CAT-5 wire to the electrical box from the CA
system controller.
4. Use a 110 punchdown tool to connect each wire to
its corresponding color labeled on the punchdown
terminal.
5. Mount the keypad in the electrical box. For the KP4 key-
pad, insert the source name labels in the appropriate slots	Back
before attaching the back plate and trim plate.	Back
	Plate

DVD CABLE

XM1 AM/FM

Source

KP4 Keypad

Trim

Plate