GE JV347*, JN327, JV367*, JV338*, JV348*, RN328 installation instructions Using the hood controls

Page 4

Safety Instructions

Using the hood controls.

Throughout this manual, features and appearance may vary from your model.

Control Knobs (on some models)

 

Switch Pad Controls (on some models)

 

 

 

 

ON

HI

 

OFF

 

OFF

OFF

LO

HI

 

ON

 

 

OFF

LO

 

MED

NITE

 

 

 

Operating Instructions

FAN Control

Turn to HI, MED or LO as needed.

Continuous use of the fan system while cooking helps keep the kitchen comfortable and less humid. It also reduces cooking odors and soiling moisture that create a frequent need for cleaning.

LIGHT Control

Turn to ON while cooking or to NITE for use as a night light.

LIGHT Control

Press the pad at the top to turn the light ON.

FAN Control

Press the pad at the top to turn the fan on HI and at the bottom to turn it on LO. The center position is OFF.

Continuous use of the fan system while cooking helps keep the kitchen comfortable and less humid. It also reduces cooking odors and soiling moisture that create a frequent need for cleaning.

Installation Instructions

Care and cleaning of the vent hood.

Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood.

Reusable Metal Grease Filter—Ducted Installations Only

Consumer Support

Grease filter

4

The efficiency of your hood depends on a clean filter. Frequency of cleaning depends on hood use and the type of cooking you do. However, the grease filter should be cleaned at least once a month.

To remove:

Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back.

To replace:

Slip the back edge of the filter into the retaining tabs and push the front edge up until it snaps into place.

To clean:

Soak and then agitate it in a hot water and detergent solution. Light brushing can be used to remove embedded dirt. Rinse, shake and let it dry before replacing.

NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE.

With careful handling, the metal filter will last for years. If a new replacement filter becomes necessary, order the part from your dealer. Order genuine GE part number WB02X8391.

Image 4
Contents Range Hoods Safety Precautions Lisez ET Conservez CES Instructions Using the hood controls Instructions Ductwork Requirements Exhaust connectionMaximum duct length Elbows, transitions, wall and roofcaps, etcInstallation Instructions WORKSHEET-CALCULATE Total Equivalent Ductwork LengthDamage SHIPMENT/INSTALLATION Mounting SpaceTools YOU will Need Parts IncludedChoose Vent Option Remove Wiring Cover Reverse the Baffle for Ducted Installations onlyRemove Wiring Knockout Remove Exhaust AdaptorFor 7″ Round Vertical Ducted Discharge Installations only For RECESSED-BOTTOM Cabinets onlyMark Holes RUN WiresCUT Holes Optional Power Cord KIT JXHC1 Feed in WiresConnect Ductwork to Hood Ducted installations only Screw in PartwayInstall Light Bulb Follow Electrical Code Connect WiringReplace Wiring Cover Troubleshooting ChecklistGE Range Hood Warranty Consumer Support GE Appliances Website
Related manuals
Manual 16 pages 25.21 Kb