GE JV396, JV930, JV394, JV395 operating instructions Use and Care & Installation Guide

Page 1

Use and Care & Installation Guide

30 Vented Hood

Safety Instructions...Front Cover, 2

Operating Instructions

.........2, 3

Automatic Heat Sensor

3

Controls

2

Cleaning

3

Filter

3

Light Bulb Replacement

3

Installation

4–6

Damper/Duct Connector

5

Electrical Wiring

6

Filter Panel

3, 5

Mounting Brackets

5

Consumer Services

7

Important Phone Numbers

7

Warranty

Back Cover

IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING.

SAFETY PRECAUTIONS

WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

A.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.

B.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

C.Do not use this unit with any solid-state speed control device.

D.Use with approved cord-connection kit only.

E.This unit must be grounded.

WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

A.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

B.Always turn hood ON when cooking at high heat or when cooking flaming foods.

C.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

D.Use proper pan size. Always use cookware appropriate for the size of the surface element.

(continued next page)

GE Appliances

Models: JV394 JV395 JV396 JV930

Image 1
Contents Use and Care & Installation Guide Controls Operating InstructionsLight Bulb Replacement Care and CleaningAutomatic Heat Sensor FilterMark and cut out the cabinet bottom Installation InstructionsSet the housing into the opening Attach the damper/duct connectorRemove the access cover Open the filter panel Install the mounting bracketsConnect the electrical wiring Replace the access coverInstall the glass visor assembly Fine adjustments to the visor trim positionWe’ll Be There Warranty