Installation Instructions
[] REMOVE EXHAUST ADAPTOR
I),emo_e the 7" round exhaust adaptor fl'om the top ot
tile hood. Set it aside along with its m o/mting screws.
[] REMOVE FILTERS
ReIllOve tile shipping tape holding tile metal grease
filters ill place. Pull down on tile filter tabs and lift
tile filters out. Set theln aside.
Filters
[] REMOVE BOTTOM COVER
()n inodeJs so equipped, relno',e tile bottom cover
ti'om tile hood. Set tile co',er and its inounfing screws aside.
Bottomcover
(heldin place with 2
screws)
[] REMOVE OTHER EXHAUST ADAPTOR
ReI/love tile 3¼" x 10" rectaaagulaJr exhaust adaptor
from inside tile hood. Set it aside along with its
mounting screws and parts bag. Depending on tile
Inodel, the exhaust adaptor will be located on the lett or right side.
3V4"x 10" | 3V4"x 10" |
rectangularrectangular
exhaustadaptorexhaustadaptor
16_REIVIOVE WIRING COVER
On inodels so equipped, relnoxe tile wiring cover
fl'onl inside tile hood. Set tile coxer and its inounfing screw aside.
Wiring cover
[] REMOVE WIRING KNOCKOUT
Remoxe either tile top or tile back wiring knockout as
needed and install an approxed strain refief clamp.
Strain relief clamp
11