Mark Holes, For RECESSED-BOTTOM, CUT Holes

Installation Instructions

[] MARK HOLES

Select the xent option that _our installation will

require and proceed to that section:

A.Outside top exhaust

(Vertical duct--31/4" x 10" Rectangular)

•Use the diagran_ or the hood as a template and

mark the locations on the cabinet for ductwork,

electrical wiring and keyhole screw slots.

Hood mounting screws (4)

131_6" (30" hood) (36"

I'		Electricalaccesshole {
Wood shims(recessed- _"		(in cabinetbottom)
	Center	(in cabinetbottom)
bottomcabinetsonly)	line

B. Outside top exhaust (Vertical duct--T' Round)

•Use the diagram or the hood as a template and

mark the locations (m the cabinet for ductwork,

electrical wiring and keyhole screw slots.

Hoodmountingscrews(4)

131_6"(30" hood)	131%d' (30" hood)
hood)

101//'

D.Recirculating (non-vented ductless-- Available on JV5 Series models only)

•Use the hood as a template and mark rite locations

on the cabinet for the electrical wiring and keyhole screw slots.

•Since the hood is to be recirculated (not to be vented

outside), do not cut out am xent oi)enings, in the wall or cabinet bottom.

[] FOR RECESSED-BOTTOM

CABINETS ONLY

•If the cabinets have fl'ont, side or back trim, make

2 wood shims the width of the trim and attach them

to the cabinet bottom recess on both sides. See Step

12 for marking locations.

[] CUT HOLES

Cut holes at marked locations for duct and electrical

wiring. For the vertical duct, cut ()tit 3/4" extra toward the fl'ont of the cabinet so you can move the

duct fl'eely when installing the hood. It may also ease

installation by cutting the hole 10½" instead of 10".

Electrical access

Wood shims (recessed- Center hole (in cabinetbottom}

bottom cabinets only)

line

C.Outside rear exhaust

(Horizontal duct--31/4" x 10" Rectangular)

•"Use the diagram or the hood as a template and

mark the locations on the cabinet for ductwork,

electrical wiring and keyhole sc_'ew slots.

Wood shims (recessed-bottomcabinetsonly)

	[!_Cabinetl				"I_--_fr°nt _y/4"j¢' ___i___			'
/'[	7--7							I
/'[	t	>'1,o_,zo,,r_, ITqoct_:_						I
flCabinet		±'	accessh,le			I	I_	I
\	[bottom	_51/4"		_	_--51/4"	-_	I "--4
\	15			_	_	15
\	_--13 >6" (30"hood)					13/16"(30"hood) _,_ /
\	-- 16_6" (36"hood}					161_16"(36"I_ood)		'
\						Electrical access hole
Hood mounting screws (4)						O0wall)

[] RUN WIRES

Run the electrical wires through the wall or

cabinet according to National Electrical Code

and applicable h)cal codes.

NOTE: DO NOT mrn the power on until

installation is complete.

[] SCREW IN PARTWAY

Drixe a mounting screw (from the hardware packet)

partwa) into each center of the narrow neck of the

keyhole slots marked on the cabinet bottom.

[] FEED IN WIRES

I,ifl the It()()(] into position and feed the house

IviI'i ng throuoh_ the wirin,,_ knockout.