Remove Duct Knockouts | GE JV655 specification

Installation

[] REMOVE DUCT KNOCKOUT(S)

If recirctdath_g, non-vented ductless (Ol_tional for ,IV5 Series models only), see uote below and skip to

Step 12 D and proceed. We do not recommend the

recirculated configuration for JV6 Series models.

Using a fiat blade screwdriver; remove the ai_i_ropriate

duct lmockout(s) fi'om the top or back of the hood.

3'/4"xI0" Rectangular	7" Roundvertical
vertical discharge•	discharge, Removesemi-
Removetop rectangular	circularduct knockoutandtop
ductknockoutonly.	rectangularductknockout.

3'/4"x 10" Rectangular

horizontal discharge• Remove

rear rectangular duct knockout only.

NOTE: If the hood is to be installed in a recirculating,

non-vented ductless manne_; order charcoal filters,

kit nmnber WB02X10707 fin" 30" hood models or

kit ntlillbeF WB02X10708 fin" 36" hood models.

These kits can be ordered ti'om yore" GE sui_plie_: Skip to Step 12 D mid proceed.

[] FOR HORIZONTAL DISCHARGE

INSTALLATIONS ONLY:

Remove the plate (on models so equiI)ped ) in fl'ont

of the horizontal discharge knockout. Cut the ties, lift plate out and discard plate. DO NOT REMOVE the metaJ strip held in place with two screws.

Metal strip Ties

Screw

Instructions

[] FOR 31/4" X 10" RECTANGULAR

DUCTED DISCHARGE INSTALLATIONS ONLY:

Mtach exhaust	adaptor/da_aper		over	knockout
opening with	two exhaust	adaptor	screws.		Make sure
damper pivot	is nearest	to top/back		edge	of hood.
Remove tape ti'om damper flap.
Upto 1" side-to-					Tape
sideadjustment

Pivot

Exhaustadaptor/damper

(verticaldischargeposition

shown)

NOTE: The exhaust

adai)tor/damper

can be installed

up to 1 inch on either side of the hood center to

aCCOlillilo(late off=center ductwork. ]n extreme off =

center installations, one end of the duct connector may

need to be trimmed to clear the electrical cable clamp.

[] FOR 7" ROUND VERTICAL

DUCTED DISCHARGE INSTALLATIONS ONLY:

Re-install the 7" round exhaust adaptor with its

screws, removed in Step 2 trader the "Prepare the Hood" section.

NOTE: The 7" rotmd exhaust adaptor can be installed up to 1 inch on either side of the hood center to

aCCOllllllodate

oItcenter

dtlctwork.

In exti'ellle

oItLcenter

instnllations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.

NOTE: The 7" r(mnd damper is not included with this i_roduct. It can be i_m'chased as a kit b) calling

800.626.2002. Order kit nmnber,]'X[ A2..

Installation