Z40EdwardsStreetSE
C',eveiand]enness._373ile
Fax:423,i78670
NOTE: Check the vertical handle position by using one short perimeter visual guide, first place it directly above the chromed handle endcap on
trim piece. Using the trim piece as a the freezer door. Open and sight down
the top edge of the door panel If light can be seen between the top edge of the door panel and the foam
adhesive on the perimeter trim, the upper chromed endcap on the handle will need to be adiusted downward
until foam tape makes contact. If light cannot be seen, use the same procedure to check the refrigerator door.
If no adjustment is needed, proceed to Step 6.
If the upper portion of the handles need attjustment, proceed according to the following instructions:
TOP EDGE OF DOOR: | With a | phillips screwdriver, | proceed | to remove | the | upper chromed endcap. |
| ||||||
Remove | the | top plastic | handle | trim | extension. | File off | the top | of the trim | lock | the amount | necessary | to elimi- | |
nate the | light | previously | seen. | Do | not remove | more than 1/32". | Reinstall | the | components | that were | removed | ||
and check the trim fit. |
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
| £ND CAP _ | z | T |
|
|
|
|
|
| |
|
|
|
| 5C_W5 | _ | _ | END CAPS |
|
|
|
| ||
|
|
|
|
|
| LI, Xr NSIONS |
|
|
|
| |||
|
|
|
|
|
| _ | " |
| LOCKS |
|
|
| |
If you are satisfied with the fit, proceed to Step 6.
6.Using black tape provided in kit. cut appropriate lengths to be applied to the door panel at the top and bot-
tom of the hahdle opening on the freezer and refrigerator doors. On dispenser models, remove the screw from the bottom of the dispenser escutcheon and discard. Move the selector switch to "ice" and slide the escutcheon
frame to the left to remove it. Apply tape as shown for dispenser. Reinstall the escutcheon frame.
_lttd_TE_XP[NG_E.t_SHJIO.N_DL'CAEP.S
| A_mlra _ | "_:_a_jic Chef |