240EdwardsStreetSE. C1eveandTennes.s37311ee
fax _23-478-8710
32.Install the shorter
33.Peel back approximately three to four inches of the protective backing from each end of the foam tape on the freezer top and bottom trim. Crease to form pull tabs.
34.Slide the lower customer 1/4" thick panel into the lower
35.Install top and bottom trim pieces following Step 19.
36.On the magnet backed side trim piece, peel back approximately three inches (half) of the protective back- ing from the top of the foam tape and crease to form a pull tab.
37.Place the
Pull off the tape backing to expose tape adhesive to the door edge. Press down firmly to insure proper bonding.
38.Install right side trim piece as in Step 21.
39.Use the template provided to locate the nameplate in the upper right band comer of the refrigerator door as shown. Remove the protective backing from the nameplate and securely mount it to the decorator panel.
40.If there happens to be interference between the perimeter trim and the top hinge cover, extra shims have been provided in the kit to be placed beneath the top hinge to alleviate any interference problems.
NOTE: Shoutd it ever become necessary to remove the dispenser escutcheon to service the ice/water dispenser, the left hand magnetic side trim must be moved. Use care to avoid damage to the trim piece. If the trim piece
was removed without damage, remove the 6 inch piece of tape and apply a new strip of tape. Reinstall side trim piece after fountain service.
IMPORTANT: ONCE YOU HAVE COMPLETED INSTALLATION OF THE KIT, CHECK THE FIT
OF THE PERIMETER TRIMS ON ALL CORNERS. IF THERE ARE ANY SHARP EDGES, CARE- FULLY FILE OFF WITH A FINE TOOTH FILE TO FORM BEVELED CORNERS.