Maytag RAX3300CXX, RAX3600CXX installation instructions C0 0merSe ic

C0 0merSe ic

240EdwardsStreet,SE

C',evelanc,Tennessee37311 Tel:423-_72-3333 Fax:429--t78-6718

INSTALLATION OF FREEZER DECORATIVE PANEL

22.If you have a non-dispenser model, basically follow the same procedures as outlined in Steps 8 through 21 to install the freezer door decorator panel and trim, ten proceed to Step 38. If you have a dispenser model,

continue with Step 22.

INSTALLATION OF FILLER STRIP

23. Peel back three to four inches of the protective backing and crease to form pull tab on the end of the filler strip that will be placed toward the top of the freezer door.

EadToward

TopOfDoor

24.Position filler strip with "soft nose" against the handle side on the right side of the door. Apply pressure to the "hard end" of the filler strip to slightly compress the "soft nose" against the handle. Then press down

firmly to insure proper bonding.

PL'LL

!

TOPt)FOCOR ).

Er-dCa;re.s.,i...ti. tt,_is i

PrL_ _l_vrl T'o [n_urtz

pTrloer _,,odin,_' !t) O.,_e

IMPORTANT: Once adhesive bonds to the door panel, it cannot be removed. Make sure you align filler strip properly as you work towards the bottom of door.

25. As you work toward the bottom of the door, pull tape backing to expose adhesive to the door panel.

_'_ MA_ rAG &dmlral _J "Pi_'l'zUENN .#JR _#"_(ji¢C,: '_e