240EdwardsSt[eetrSE ClevelandTennessee37311,
TRIM KIT INSTALLATION INSTRUCTIONS
SIDE BY SIDE REFRIGERATORS
RAX3300CXX AND RAX3600CXX
Read through these instructions thoroughly before proceeding. Proper installation is your responsibility.
WARNING: TO AVOID DANGER OF SUFFOCATION, KEEP ALL PLASTIC FILMS AND PLASTIC
BAGS AWAY FROM CHILDREN, DESTROY IMMEDIATELY AFTER OPENING. THE FILMS AND BAGS ARE NOT TOYS !
Make sure you have all tools and parts necessary for correct installation. Special care should be taken when removing parts from their packing to avoid possible damage. When installing decorator panels and perimeter trims, work on one door at a time.
Read each step of the instructions carefully. Decorator panels and perimeter trim once applied cannot be easily
TOOLS REQUIRED FOR THIS INSTALLATION: |
| '_ | _[_ | |
removed. |
|
| ||
Putty Knife | 5/16" Socket | I |
| |
File | Isopropyl Alcohol (rubbing alcohol) | _ |
| ___,_ |
Phillips Screwdriver | Rag |
|
|
|
Scissors | Long Nose Pliers |
|
|
|
Hammer
Drill with 5/64" diameter metal bit
1.Use a putty knife to pry off the nameplate. Discard. If there are two nameplate retainers in the door panel, remove with long nose pliers. Discard parts.
"
2. Remove door stop from bottom of refi'igerator and freezer doors. Discard.
3.Remove the silver trim strip from side of each door. Remove any adhesive that remained on the door edge. Use isopropyl alcohol to ease adhesive removal.
4.Wipe all sides and front of freezer and refrigerator doors with isopropyl alcohol to insure a clean surface for the foam tape on the perimeter trim and decorator panels to adhere to.
5, Carefully remove door trim and other installation components from the adaptor kit packing.