Installation Instructions
WALL INSTALLATION
FOR MODELS PVWS930, PVWS936, PVWT936 AND PVWG936 ONLY
(For model PVIG940 installation, please refer to the paragraph "CEILING INSTALLATION" on the next pages).
1.Choose the assembly height which is most convenient for the user and mark the wall behind the hob.
2.Mark the centre line of the hood and trace the vertical line from the bottom of the hood to the ceiling.
3.Fasten the template using adhesive tape, making sure the centre line corresponds with the bottom of the hood.
4.Mark the centre of the fixing points (6 fixing points for models PVWS930/936 and PVWT936; 4 fixing points for model PVWG936) through the template on the wall and then remove the template.
5.Trace a horizontal line on the wall 1” above the highest fixing point and 1” below the lowest fixing point.
6.Find studs behind drywall by tapping wall or using a stud finder. Mark the center of the studs with a vertical line to the right and left of the marked fastener location.
7.Note: All fastener location must span the studs otherwise proceed as follows:
•Cutout drywall along marked lines.
•Install wood blocking between studs and make sure it is flush with existing stud front. Make sure all mounting screws will anchor to added studs.
•Replace drywall and refinish.
8.Mark the centre line again and the bottom of the hood in same position as before and fasten the template to the wall using adhesive tape as indicate above at point 3.
Models PVWS930/936 and PVWT936
A.Centerline
B.Mounting Hook Location
C.Fastener Locations
D.Mounting Height Reference
E.Template
Model PVWG936
A.Centerline
B.Mounting Hook Location
C.Fastener Locations
D.Mounting Height Reference
E.Template
9.Models PVWS930/936 and PVWT936:
Attach the 2 hooks with leveling screws (provided in the assembly kit) to the points marked on the template with 2 screws and then remove the template.
Model PVWG936:
Screw 2 screws on lower fixing point but do not tighten them completely (leave a space of ½") they will serve to hang the hood canopy.
Models PVWS930/936 and |
| Model PVWG936 | ||
PVWT936 |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ø 6 x 80
Ø 6 x 80
A.Centerline
B.Mounting Hooks (screws)
C.Fastener Locations
10.Install the bracket flush with the ceiling using the drywall anchors provided with the appliance.
Models PVWS930/936 and |
| Model PVWG936 | ||
PVWT936 |
|
|
| |
Ø 10 x 60 | Ø 6 x 80 |
| Ø 10 x 60 |
|
|
|
| Ø 6 x 80 | |
|
|
|
|
|
11.Determine and make all necessary cuts in the wall for the vent system. Install the vent system before the canopy hood. See „Venting methods“ paragraph.
12.Determine the required height for the conduit and cut a 1¼" hole at this location. Run wires through hole according to the National Electrical Code or CSA Standards and local codes and ordinances. Note: If a
There must be enough power supply cable from the fused disconnect (Or circuit breaker) box to make the connection in the hood’s Junction box/es.
Use caulking to seal all openings.
Do Not turn on power until installation is completed.
1Ft = 0.3 m 1” = 2.5 cm
1 2