Installation Instructions
B
Electrical Connections
ATTENTION INSTALLER
All electric wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products.
DO NOT shorten the flexible conduit. The conduit strain relief clamp must be securely attached to the junction box and the flexible conduit must be securely attached to the clamp. If the flexible conduit will not fit within the clamp, do not install the oven until a clamp of the proper size is obtained.
NOTE TO ELECTRICIAN: The 3 power
Turn off the circuit breaker or remove
B1 fuses to the oven branch circuit.
With the oven supported on a table or
B2 platform in front of the cabinet opening,
connect the flexible conduit to the electrical junction box as shown below. Position the conduit in such a manner that it will lie on top of the oven in
a natural loop when the oven is installed. You will need to purchase an appropriate strain relief clamp to complete the connection of the conduit to the junction box.
20”
leads supplied with this appliance are UL recognized for connection to heavier gauge household wiring. The insulation of these 3 leads is rated at temperatures much higher than the temperature rating of household wiring. The current carrying capacity of the conductor is governed by the wire gauge and the temperature rating of the insulation around the wire.
WARNING: Improper
connection of aluminum house wiring to copper leads can
result in an electrical hazard or fire. Use only connectors designed for joining copper to aluminum and follow the manufacturer’s recommended procedure closely.
Conduit
48 1/2” long
Place oven on a support to assist in connecting conduit
Junction Box
Location
GROUND
WIRE
BARE
GROUND
RED
WHITE
BLACK
Strain Relief Clamp (not included) must be used at Junction Box
6
(Continued on following page)