GE JTP86 C3 Preparing for the Bottom Trim Installation, C4 Installing the Metal Bottom Trim

Installation Instructions

To install a single metal bottom trim assembly (on some models), use sections C3 and C4.

To install a metal bottom trim with a plastic bottom trim (on some models), use sections C3–C5.

C3 Preparing for the Bottom Trim Installation

a. With oven installed, take the bottom trim and center it on the bottom front edge of the cabinet opening.

b. Using the trim	With Lower Trim
as a template,	in Position, Mark
	(2) Mounting Hole
mark the center	Locations
of each slot
(two total) where
the mounting holes		Remove
will be drilled.
		Lower Trim
c. Remove the trim.		Before
		Pre-drilling
d. Drill pilot holes into the center		Mounting
		Holes
of each template mark.

C4 Installing the Metal

Bottom Trim

a. Place the bottom metal trim centered over the pre-drilled mounting holes. Tape the edges of the trim down to maintain the alignment.

b. Using two trim screws provided, secure the bottom trim to the bottom edge of the cabinet. If a plastic bottom trim is supplied, proceed to C5.

Side

Trim

Trim Screws

Side

Trim

Metal Lower Trim

IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service, the trim must be removed first or damage to the trim will occur.

C5 Installing the Plastic Bottom

Trim (on some models)

a. Make sure flat side is up on the plastic bottom trim.

b. Find the key slot on the back of the trim.

Key Hole Slot and Wide Flange at Top

c. Match the key slot with the rivet on the bottom of the side trim, and lower the trim onto the rivet.

Lower Trim Mounting Rivet on End of Metal Lower Trim

d. Push the trim down, at both ends, until it snaps securely into place.

Push Trim Down at Both Ends

Until it Snaps Securely Into Place

CAUTION: Be sure you do not tip the oven forward

during installation or you may bend the bottom trim. The bottom trim provides an opening for cooling air to enter the cabinet. This opening should never be blocked.

9