Using Your Oven

Before Using Your Oven

1.Look at the controls. Be sure you understand how to set them properly.

2.Check the oven interior. Look at the shelves. Take a practice run at removing and replacing them properly to give sure, sturdy support.

3.Read over the information and tips that follow.

4.Keep this guide handy so you can refer to it, especially during the first weeks of using your new oven.

NOTE:

•You may notice a “burning” or “oily” smell the

first few times you turn your oven on. This is normal in a new oven and will disappear in a short time.

•A cooling fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run even after the oven is turned off.

Special Features of Your

Automatic Ignition

The oven burner is lit by electric ignition.

To light the burner, press the pad for the desired function and press the TEMP + or –

TEMP	pads until the desired temperature is displayed.
	pads until the desired temperature is displayed.
	The burner should ignite within 60 seconds.

After the oven reaches the selected temperature, the oven burner cycles off completely, then on with a full flame to keep the oven temperature controlled.

Oven Vent

When the oven is on, heated air moves through a vent behind the grille. See the Features of Your Oven section.

The vent area could get hot during oven use.

The vent is needed for proper air flow in the oven and good baking results. Do not block this vent. Doing so may cause oven failure or fire.

Oven Control

Power Outage

The oven burner will not light in the event of an electrical power outage.

Do not attempt to light it manually with a match.

Oven Shelves

The shelves are designed with stop-locks so that, when placed correctly on the shelf supports, they will stop before coming completely out of the oven and will not tilt when you are removing food from them or placing food on them.

When placing cookware on a shelf, pull the shelf out to the bump on the shelf support. Place the cookware on the shelf, then slide the shelf back into the oven.

This will eliminate reaching into the hot oven.

To remove a shelf from the oven, pull the shelf toward you, tilt the front end upward and pull the shelf out.

To replace, place the shelf	Bump
on the shelf support with
the stop-locks (curved
extension of the shelf)
facing up and toward the
rear of the oven. Tilt up
the front and push the
shelf toward the back of
the oven until it goes past
the bump on the shelf
support. Then lower the
front of the shelf and push
it all the way back.

Using Your Oven

(continued next page)

JGRS14 specifications

The GE JGRS14 (General Electric Joint Tactical Ground Station - Ground Radar Sensor 14) is a groundbreaking piece of technology designed for advanced surveillance and reconnaissance missions. It showcases GE's commitment to pushing the boundaries of ground-based radar capabilities, making it a critical asset for military and defense operations.

One of the main features of the JGRS14 is its high resolution imaging radar system, which allows for exceptional target detection at various ranges. This capability is crucial for identifying both stationary and moving targets in complex environments, ensuring operational effectiveness even in challenging weather conditions. The radar system uses advanced signal processing techniques to enhance image clarity, enabling users to achieve more accurate situational awareness and decision-making.

The JGRS14 employs a modular and scalable architecture, meaning it can be adapted to different operational needs while maintaining optimal performance. This flexibility is essential for military units that may require varying levels of surveillance capabilities depending on their mission profiles. Additionally, the system is designed for easy integration with existing military command and control networks, enabling seamless data sharing and improved collaboration among units.

A significant technological advancement in the JGRS14 is its use of artificial intelligence (AI) and machine learning algorithms. These technologies allow the system to process large volumes of data in real time, automatically identifying potential threats and providing actionable intelligence to operators. By reducing the time needed for human analysis, the JGRS14 enhances response times and operational effectiveness.

Another characteristic of the JGRS14 is its rugged design, built to withstand harsh operational environments. This durability ensures that the system remains functional during extreme conditions—whether in deserts, jungles, or cold climates. The compact and lightweight nature of the radar system also allows for easy transport and deployment, making it a valuable tool for rapid response teams.

In summary, the GE JGRS14 demonstrates cutting-edge features and technologies that significantly advance ground surveillance capabilities. With its high-resolution radar, modular design, AI integration, and robust construction, the JGRS14 is positioned to play a critical role in modern military operations, enhancing situational awareness and ensuring mission success in dynamic environments. It exemplifies the future of military radar systems, bridging the gap between technology and operational needs.