GE JGRS14 warranty Oven CONTROL, Clock and Timer

OVEN CONTROL, CLOCK AND TIMER

Clock

The clock must be set for the automatic oven timing functions to work properly.

The time of day clock cannot be changed during Delay Start. (It can be changed during a regular bake or broil operation.)

Features of

To Set the Clock

1. Press CLOCK.

CLOCK

2.Press the HOUR and MIN + or –

pads to set the time of day.

HOUR MIN

3.Press START. This enters the time and

START starts the clock.

To check the time of day when the display is showing other information, simply press CLOCK. The time of day shows until another pad is pressed.

Your Oven Control

Timer

You may program the timer to time cooking or other household activities for up to 9 hours and 59 minutes.

The timer counts down in minutes, 1 minute at a time, until the last 60 seconds are reached, then the control will beep one time. The seconds will not be displayed until the last minute is reached.

When the timer reaches “ :00,” the control will beep 3 times followed by one beep every 6 seconds until KITCHEN TIMER ON/OFF is pressed.

The 6 second tone can be canceled by following the steps in the Special Features of Your Oven Control section under Tones at the End of a Timed Cycle.

How to Set the Timer

K I T C H E N		1. Press KITCHEN TIMER ON/OFF.
T I M E R
ON OFF
		2. Press the HOUR and MIN + or –
HOUR	MIN	pads until the amount of time you
		want shows in the display.
		If you make a mistake, press
		KITCHEN TIMER ON/OFF
		and begin again.

	3. Press START.
START	After pressing START, “SET” disappears;
	this tells you the time is counting down,
	although the display does not change until
	one minute has passed.
K I T C H E N	4. When time is up, the oven control signals
T I M E R	until you press KITCHEN TIMER ON/OFF.
ON OFF	Display then shows the time of day.

NOTE: The minute timer is independent of all the other functions and it does not control the oven. The CLEAR/OFF pad does not affect the timer.

Oven Control, Clock

Power Failure

If a flashing time of day is in the display, you have	To reset the clock, press CLOCK. Enter the correct
experienced a power failure. Reset the clock.	time of day by pressing the HOUR and MIN + or –
	pads. Press START.
	(continued next page)

7

and Timer