OPEMT~G T~ SELF-CLEAN~G Oven, After a Clean Cycle

OPEMT~G T~ SELF-CLEAN~G OVEN

(continued)

How to Set the Oven for Cleaning

Quick Reminder:

1.Prepare the oven for cleaning.

2.Close the oven door completely.

3.Slide the latch handle to the right as far as it will go.

4.Press the CLEAN pad.

5.Press the INCREASE or DECREASE pad until the desired Clean Time appears.

If the oven is too hot and you start to set a clean cycle, the word “OFF” will appear in the display. Allow additional time for cooling before you try to

set the cycle.

1.Follow directions to prepare the oven for cleaning.

2.Slide the latch handle to the right as far as it will go.

	Never force the latch	?
	Never force the latch	f
	handle. Forcing the handle	*
	will damage the door lock	*
	will damage the door lock

mechanism.

n 3. Press the CLEAN pad.

CLEAN

1 J

4.Press the INCREASE or DECREASE pad until the desired Clean Time is displayed.

Clean Time is normally 3 hours. You can change the Clean Time to anywhere between 2 and 4 hours, depending on how dirty your oven is.

The self-clean cycle will automatically begin after “CLEAN” is displayed and the time for the clean cycle is set. The words “ON” and “LOCK” will appear on the display. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCK light goes off.

5.When the LOCK light is off, slide the latch handle to the left as far as it will go and open the door.

The word “door” will be displayed, the word “LOCK” will flash and oven control will signal if you set the clean cycle and forget to close the oven door.

If “F-” and a number flash in display and the

control beeps, this indicates function error

code. If function error code appears during the self-cleaning function, check the oven door latch—the latch handle may have been moved, even if only slightly, from the latched position. Make sure the handle is to the right as far as it will go. Press the CLEAWOFF pad. Allow the oven to cool for 1 hour. If function error code repeats, disconnect power to the range and call for service.

After a Clean Cycle

After cleaning is complete, the oven door will stay locked until the oven cools. If you cannot slide the latch easily to unlock the door, allow additional time for cooling.

Never force the latch handle. The latch slides

easily. Forcing the latch handle may damage the

door lock.

You may notice some white ash in the oven. Just wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap- filled steel wool pad. Be sure to rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after 1 clean cycle,

repeat the cycle.

NOTE: No functions can be programmed before the door automatically unlocks.