GE JRP 28 owner manual Operating Instructions Care

	www.GEAppliances.com
Control Panel
It’s a good idea to wipe the control	Do not use abrasive cleansers, strong
panel after each use. Clean with mild	liquid cleansers, plastic scouring pads or
soap and water or vinegar and water,	oven cleansers on the control panel—they
rinse with clean water and polish dry	will damage the finish. A 50/50 solution of
with a soft cloth.	vinegar and hot water works well.

Safety Instructions

Molded rib

Spring clip

Clear groove in stem

Knob

The control knob (lower oven only) may be removed for easier cleaning.

Before removing the knob for cleaning, please note that the knob is in the OFF position. When replacing the knob, check the OFF position to insure proper placement.

Painted Surfaces

Clean with soap and water or a vinegar and water solution.

Wash the knob in soap and water or a vinegar and hot water solution but do not soak.

The knob stem is D shaped. Install the flat of the shaft to the flat of the knob.

Do not use commercial oven cleaners, cleansing powders, steel wool or harsh abrasives on any painted surface.

Operating Instructions Care and

Glass Surfaces

To clean the outside glass finish,	Do not allow the water or cleaner
use a glass cleaner. Rinse and polish	to run down inside the oven door
with a dry cloth.	while cleaning.

Stainless Steel Surfaces (on some models)

Cleaning

Do not use a steel-wool pad; it will scratch the surface.

To clean the stainless steel surface, use warm sudsy water, a stainless steel cleaner such as Kleen King® or an all-purpose liquid or spray cleaner. Always scrub in the direction of the grain. Rinse thoroughly with a sponge or cloth and clean water. Dry with a soft, clean cloth.

After cleaning, use a stainless-steel polish, such as Stainless Steel Magic®, Revere Copper and Stainless Steel Cleaner® or Wenol All Purpose Metal Polish®. Follow the product instructions for cleaning the stainless-steel surface.

Troubleshooting Tips Consumer Support

21