Using the oven controls, Support, Cooking

Using the oven controls.

www.GEAppliances.com

Throughout this manual, features and appearance may vary from your model.

Upper Oven Control, Clock and Timer Features and Settings

BAKE Pad	START Pad
Touch this pad to select the bake function.	Must be touched to start any cooking function.

Safety Instructions Operating Instructions

BAKE Light

Flashes while in edit mode—you can change the oven temperature at this point. Glows when the oven is in bake mode.

BROIL HI/LO Pad

Touch this pad to select the broil function.

BROIL Light

Flashes while in edit mode—you can switch from HI to LO BROIL at this point. Glows when the oven is in broil mode.

Display

Shows the operations you have selected, the time of day and the cooking status.

COOKING TIME Pad

Touch this pad and then touch the + or – pad to set the amount of time you want your food to cook. The oven will shut off when the cooking time has run out.

DELAY START Pad

Use along with the COOKING TIME or

SELF CLEAN pad to set the oven to start and stop automatically at a time you set.

OVEN LIGHT ON/OFF Pad

Touch this pad to turn the oven light on or off.

TIMER/CLOCK Pad

Touch this pad to select the timer feature. Then touch + and – pads to adjust time.

To set the clock, touch this pad twice and hold 3 seconds and then touch the + and – pads. The time of day will flash in the display when the oven is first turned on.

– Pad

Short taps to this pad will decrease the time or temperature by small amounts. Touch and hold the pad to decrease the time or temperature by larger amounts.

+ Pad

Short taps to this pad will increase the time or temperature by small amounts. Touch and hold the pad to increase the time or temperature by larger amounts.

CLEAR/OFF Pad

Touch this pad to cancel ALL oven operations except the clock and timer.

SELF CLEAN Pad

Touch this pad to select the self-cleaning function. See the Using the self-cleaning oven section.

CLEAN Light

Flashes while in edit mode—you can change the length of time for the self-clean cycle at this point. Glows when the oven is in the self-clean cycle. After the self-clean cycle, the light will turn off. Unlatch the door.

If “F– and a number or letter” flash in the display and the oven control signals, this indicates a function error code.

Touch the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation.

If function error code repeats, disconnect power to the oven and call for service.

Care and Cleaning Troubleshooting Tips Consumer

Lower Oven Control

OVEN TEMP Knob	The OVEN CYCLE light glows until the oven reaches your selected
Turn this knob to	temperature, then goes off and on with the oven element(s) during
the temperature	cooking.
setting you want.
	5