GE JBP87GD, 49-4540 manual How, Lamp

How

The porcelain enamel finish is sturdy but breakable if misused. This finish is acid resistant. How- ever, any acid foods spilled (such as fruit juices, tomato, or vinegar) should not be permitted to remain on the finish.

jA!c21==x-L)gyo- J! (’7J~

To Remove:

@Remove the 3 siotted screws in the lamp cover as shown in diagram,

Use time given on recipe when cooking first time. Oven thermo- stats, in time, may “drift” from the factory setting and differences in timing between an old and a new oven of 5 to 10 minutes are not unusual. Your oven has been set correctly at the factory and is more apt to be accurate than the oven which it replaced. However, if you find that your foods consistently brww too little or too much, you

I

OVEN VENT OUCT

@Detach lamp cover and remove bulb.

may make a simple adjustment in the thermostat (Oven Temp) knob.

PULL KNOB OFF OF SHAFT, LOOK

/	,----------	, .-
	\	,

Your oven is vented through an opening located under the center of the control panel.

During most operations it is normal to observe moisture and/or vapor emitting from opening. Clean this area frequently.

NOTE: NEVER COVER OR BLOCK VENT OPENING. TO DO SO PRE-- VENTS THE OVEN VENT FROM FUNCTIONING PROPERLY DUR- ING COOKING OR SELF-CLEAN- ING OPERATIONS.

Lamp and

CAUTION: Before replacing your oven bulb, disconnect the elec- trical power for your range at the main fuse or circuit breaker panel or pull plug. Be sure to let the la,mp cover and bulb coo! completely before removing or replacing,

,To Replace:

@Put in a new 40-watt appliance bulb.

o Install lamp cover. Replace 3 screws and tighten, making sure cover fits flush with oven wall.

0 Reconnect electrical power to the range.

WHEN CHANGING A COOKTOP LAMP, DO NOT TOUCH THE METAL AT ENDS OF LAMP,

a. Remove Phillips head screws at each end of cover.

b.Place finger% on top near each end of lamp. Press down and roil top of lamp gently toward front of range until it stops. Remove.

c. Check type and wattage of lamp; replace with same kind. Hold lamp near each end and in- sert prongs into sockets. Gently roll top of lamp toward rear of range until it stops.

CL Replace lamp cover and screws. e. Connect electric power to range,

14

AT ‘BACK OF KNOB AND NOTE CURRENT SETTING, BEFORE MAKING ANY ADJUSTMENT.

To increase temperature, turn toward RAISE; to decrease turn toward LOWER. Each notch changes temperature 10 degrees. Temperature can be raised by 20 degrees or lowered by 30 degrees.

1. Remove knob, and hold so

pointer is at top of knob, Using a = pot holder or similar material, hold “skirt” of knob firmly in one hand.

Grasp handle of knob in other hand. Note position of pointer and turn handle to move pointer toward Raise or Lower. Pointer is designed not to move easily. If it is seated so it is difficult to move, pointer may be loosened slightly. Insert a thin screwdriver, knife blade or similar instrument and lift up end of pointer slightly.

2.After adjustment is made, press monitor firmly against knob. Return knob to range, matching flat area on knob and shaft. Recheck oven performance before making an additional adjustment.

-—