Test for Leaks, Check Ignition

Conversion Instructions

1CONVERT SURFACE BURNERS (cont.)

DReplace the gaskets, burner bases and electrodes. Install the two screws in each burner base. Do not overtighten. The maximum torque is 10 inch pounds. Push the igniters all the way down into the burner head.

EInstall the burner heads, burner caps and grates in their original burner positions.

2CONVERT THE PRESSURE REGULATOR

ALocate the pressure regulator under the rear of the cooktop.

Pressure regulator

BRemove the nut from the pressure regulator with an adjustable wrench.

Natural gas

Nut

LP gas

CRemove the plastic pin from the inside of the nut, turn the pin 180° and snap the pin back into the nut.

Natural gas

LP gas

Nut

DRe-install the nut onto the regulator.

EApply the LP Conversion label next to the Rating Plate.

3TEST FOR LEAKS

WARNING: DO NOT USE A FLAME TO CHECK FOR GAS LEAKS! Do not use the cooktop until all connections have been leak tested.

Perform leak test per the following instructions:

1.Purchase a liquid leak detector or prepare a soap solution of one part water, one part liquid detergent.

2.When all connections have been made, make sure all cooktop controls are turned to OFF and turn the gas supply valve to ON.

3.Apply the liquid leak detector or the soap solution around all connections from the shut-off valve to the cooktop.

4.A leak is identified by a flow of bubbles from the area of the leak.

5.If a leak is detected, turn the gas supply off. Tighten the fitting. Turn the gas on and test again.

If the leak persists, turn the gas supply off and contact your dealer for assistance. Do not attempt to operate the cooktop if a leak is present.

4CHECK IGNITION

AConnect electrical supply cord.

BPush in one control knob and turn to the LITE position. The igniter will spark and the burner will light. The first test may require some time, while air is flushed out of the gas line.

CCheck to determine if your burner flames are normal. If burner flames look like A, call for service. Normal burner flames should look like B or C, depending on the type of gas you use. With LP gas, some yellow tipping on outer cones is normal.

A–Yellow flames	B–Yellow tips	C–Soft blue flames
Call for service	Normal for	Normal for
	LP gas	natural gas

DTurn the knob to OFF.

ERepeat the procedure for each burner.