Installation
G a s Updraf t Cooktop
Step1
Install Cooktop
Note: If the cooktop is installed into a 36" base cabinet, the pressure regulator MUST BE installed to the bottom of the cooktop before the cooktop is placed into the cabinet.
•Remove packaging from the cooktop.
•To insure a good fit, position the cooktop over the cutout opening and carefully lower into place. Check edges all the way around to be sure all cutout edges are concealed and there are no gaps.
•Carefully, lift and remove the cooktop.
Gasket
Countertop
| 1/16" | Note: If the cooktop is installed in a 36" base |
|
| |
|
| cabinet, the mounting brackets cannot be |
|
| used because of interference with the cabinet |
|
| sides. In this case, the cooktop can be secured |
|
| to the cabinet with angle brackets (not |
|
| supplied). |
3/8" |
| |
| cooktop body on both sides and secure the | |
|
| bracket with those screws. Then, secure the |
|
| brackets to the cabinet sides. |
•Cut a 3/16" gasket strip in half. Peel off the backing and apply to the underside of the glass cooktop edge.
–on each side at least 3/8" from the back and as close to the edge as possible without protruding.
•Apply the other gasket strip to the underside of the glass at the front of the cooktop.
•Remove remaining adhesive backing.
•Position the cooktop over the opening, making sure that the power cord is dropped into the cabinet.
•Lower the cooktop into the cutout, pressing gently and evenly to seat.
•Insert
–Cooktop has three slots, the highest available will depend on the thickness of the countertop.
•Secure the brackets to the underside of the countertop with screws provided.
6