GE ZGU3650 Install Pressure Regulator, Connect electrical, Assemble burners, check ignition

Step2

Install

Pressure

Regulator

•Install the supplied pressure regulator and nipple in the gas line as close to the cooktop inlet as possible. Allowances for ventilation ducting may be necessary.

–Make sure the regulator is installed in the right direction.

•Install a manual shut-off valve in the gas line in an easily accessible location.

Note: Instead of using solid piping to connect to pressure regulator, an approved flexible metal appliance connector may be used between the pipe stub and the shut-off valve and the pressure regulator, if local codes permit.

–Appropriate flare nuts and adapters are required at each end of the flexible connector.

•Turn on the gas. Check for leaks using a liquid leak detector at all joints in the system (the pressure test nipple is adjacent to the gas inlet pipe on the rear right hand side of the cooktop bottom.

CAUTION Do not use a flame to check for gas leaks.

PRUDENCE IL NE FAUT PAS UTILISER DE FLAMME POUR VÉRIFIER S’IL Y A DES FUITES.

Regulator

Solid Piping or Flexible Connector

Shut-Off

Valve

Pipe Stub

IMPORTANT: Disconnect the cooktop and the individual shut-off valve from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig. Isolate the cooktop from the gas supply piping system by closing the individual manual shut-off valve to the cooktop during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig.

Step3

Connect electrical

•Plug power cord into properly grounded receptacle.

Step4

Assemble burners, check ignition

•Assemble burner as shown. Check to be sure that burner heads are securely seated and caps are positioned as shown.

Burner Grate

Burner Cap

Burner Head

Burner Bowl

•Check for proper ignition:

–Push in one control knob and turn 90° to HIGH position.

–The igniter will spark and the burner will light; the igniter will cease sparking when the burner is lit.

–First test may require some time, while air is flushed out of the gas line.

–Turn knob to OFF.