Tools and
Materials
Required
Cut the Opening
|
|
| Installation Preparation | ||
|
|
|
|
| |
|
|
|
| G as Updraf t Cooktop | |
|
|
|
|
| |
| • | • Carpenter’s square | • 1/2" NPT x 3/4" | • 5 foot | |
| (supplied) | • Pipe wrench | I.D. or 1/2" I.D. | flexible metal | |
| • Two clamping | • Manual gas line | flare union adaptor | appliance connec- | |
| brackets and | for connection to | tor, 3/4" or 1/2" | ||
| screws (supplied) | • 3/4" NPT x 3/4" | regulator | I.D. to match gas | |
| • Gas pressure | I.D. or 1/2" NPT x | • | supply line: | |
| regulator (supplied) | 1/2" I.D. flare | joint sealant | ||
| • Large | union adaptor for |
|
| codes, use solid |
| screwdriver | connection to |
|
| pipe with fittings. |
| • Saw | supply line |
|
|
|
|
|
|
|
| Note: Purchase new |
|
|
|
|
| flexible line, DO |
|
|
|
|
| NOT USE OLD, |
|
|
|
|
| PREVIOUSLY USED |
|
|
|
|
| FLEXIBLE LINE. |
|
|
|
|
|
|
to Side Wall | Min. | |
Cutout | ||
To Side | ||
Cutout to Vertical | ||
Wall | ||
Combustible Surface | ||
| ||
| ||
| ||
Min. From |
| |
Front of |
| |
Countertop |
|
Caution: Wallcoverings, countertops and cabinets should withstand 200°F heat generated by the cooktop.
Measure carefully when cutting countertop. Make sure sides of opening are parallel and rear and front cuts are exactly perpendicular to sides.
•The Monogram gas updraft cooktop is designed to fit in a 36" or larger base cabinet.
•The countertop cutout for cooktop must be:
–
–
–Allow at least
–Allow at least
–Allow at least
•Cooktop requires 3" free space below countertop.
•If installing cooktop above a cabinet with drawers, it may be necessary to use a shorter length drawer to allow clearance for gas connection.
•In some cases, two 3/8" I.D. 45° elbows and a pipe nipple may be added between regula- tor and cooktop to move regulator further back in order to avoid interference with drawer.
4