GE ZBD5600, ZBD5700, ZBD5900 installation instructions Prepare the Opening, Water Supply

Installation Preparation

Stainless Steel Interior Dishwasher

Prepare the Opening

•The rough cabinet opening must be 24” min. deep, 23-5/8” min. to 24” max. wide. The opening height should be 34” min. and 35” max.

•The opening should be free of extraneous pipes and wires.

	This Wall Area
	must be Free of
34" to 35"	Pipes or Wires	24"
	1-3/4"
Underside		Min.
of Countertop
to Floor
		6"
	23-5/8" Min.
	24" Max

Water Supply

•Hot water line may enter from either side, from the rear, or from the floor within the shaded area shown.

•Turn off water supply.

•Cut a hole approximately 1-1/2” in diam- eter to admit water line. Access hole must be round and smooth.

•Install a hand shut-off valve in the supply line in an accessible location, such as under the sink. (The shut-off valve is optional, but recommended and may be required by local codes.)

•Install the hot water line, using no less than 3/8” O.D. copper tubing or 1/2” O.D. plastic tubing.

•The water line must be long enough to form a smooth natural loop with no sharp bends or kinks between the cutout entry and fill valve location, centered at the front of the dishwasher.

•Adjust the water heater to deliver 120°F min. water temperature.

•The water pressure of the hot water supply line must be 20 to 120 psi.

•Before connecting, flush water line to clean out debris.

Shut-off Valve	1-1/2"	Right Side Entry
	Dia.	Approx. 40"		1-3/4"
	Hole		from Wall
Hot				6"
	Left
	Side Entry
Cabinet Face	Approx. 30"
	from Wall		2" from Floor

7