GE ZBD5900 Power Supply, Electrical Requirements, Grounding Instructions, Electrical Connections

Page 8

Installation Preparation

Stainless Steel Interior Dishwashers

Power Supply

WARNING

FOR PERSONAL SAFETY:

REMOVE HOUSE FUSE OR OPEN

 

 

CIRCUIT BREAKER BEFORE BEGINNING

 

INSTALLATION.

DO NOT USE AN EXTENSION CORD OR

ADAPTER PLUG WITH THIS APPLIANCE.

FOLLOW NATIONAL ELECTRICAL

CODES OR PREVAILING LOCAL CODES

AND ORDINANCES.

AVERTISSEMENT

SÉCURITÉ

IL FAUT ENLEVER LE FUSIBLE DE LA

MAISON OU OUVRIR LE DISJONCTEUR

AVANT DE COMMENCER

L’INSTALLATION.

IL NE FAUT PAS UTILISER DE

18"

Receptacle

18" Location

Area

6" 6"

Alternate

Receptacle

Location

1-1/2" Dia. Hole (Max.)

3"

2"Cabinetfrom

2" 24" from Wall

Ground

Black

White

RALLONGE NI D’ADAPTATEUR DE FICHE AVEC CET APPAREIL. IL FAUT RESPECTER TOUS LES CODES D’ÉLECTRICITÉ NATIONAUX OU LES CODES ET RÈGLEMENTS LOCAUX EN VIGUEUR.

Electrical Requirements:

These dishwashers must be supplied with a 120 volt, 60 Hz power supply with an indi- vidual, properly grounded branch circuit, protected by a 15 or 20 amp fuse or circuit breaker or time delay fuse.

Wiring must be 2 wire with ground.

If electrical supply does not meet the above requirements, call a licensed electrician before proceeding.

Grounding Instructions:

This appliance must be either connected to a grounded-metal permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and be connected to the equipment-grounding terminal or lead on the appliance.

Cabinet Preparation & Wiring:

Wiring may enter from either side, the rear, or from the floor within the shaded area shown.

Cut hole 1-1/2” max. diameter within the shaded area to admit the electrical cable or power cord. The hole must be free of sharp edges. If the cabinet wall partition is metal, the edge of the hole must be covered with a rubber protector.

Electrical Connections:

The electrical connection is on the right side of the dishwasher.

For cable direct connections, the cable must be routed as illustrated. The cable must extend forward a minimum of 24” from the rear wall.

For power cord connections, install a

3-prong type receptacle in the rear wall of sink cabinet next to the dishwasher. Install the receptable at least 6” and not more than 18” from the dishwasher opening. The receptacle should be at least 6” and not more than 18” off the floor.

Allow approximately 3” between cable and adjacent cabinetry.

WARNING

THE IMPROPER CONNECTION OF THE EQUIPMENT - GROUNDING CONDUCTOR CAN RESULT IN A RISK OF ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE REPRESENTATIVE IF YOU ARE IN DOUBT WHETHER THE APPLIANCE IS PROPERLY GROUNDED.

AVERTISSEMENT

LE MAUVAIS BRANCHEMENT DU CONNECTEUR DE MISE À LA TERRE DE L’ÉQUIPEMENT PEUT CAUSER UN RISQUE D’ÉLECTROCUTION. EN CAS DE DOUTE SUR LA MISE À LA TERRE DE L’APPAREIL, CONSULTER UN ÉLECTRICIEN QUALIFIÉ OU UN PRÉPOSÉ DE SERVICE.

8

Image 8
Contents With Optional Trim Kit Installation Instructions Built-In DishwashersContents Product Dimensions Models AvailableDesign Information Advance PlanningOptional Trim Kits Corner installation Installation Information Parts SuppliedInstallation Preparation Tools you Will Need Not SuppliedPrepare the Opening Water SupplyPower Supply Cabinet Preparation & WiringElectrical Requirements Grounding InstructionsWaste Tee Installation Prepare drain plumbingToekick Brackets InstallationStep Step Install Water Inlet Fittings Step Level Dishwasher Slide Into Opening Step Connect Water LineStep Install Drain Line Drain Line InstallationVerify that power is turned off at the source Step Connect ElectricalSecure dishwasher to countertop Secure dishwasher to adjacent cabinetsStep Install Toekick Assembly Step Install Side TrimKit Contents Cut 1/4 Thick Custom Panel to Size Surface Test Door Balance Step Install Door SpringsInstall New Springs Kit Contents Step Determine Custom Panel SizesStep Assemble Custom Panel Step Install Door Center BracketStep Remove Existing Metal Door Rings Foam Insert Step Install Custom Toekick Stainless Steel Interior Dishwasher Monogram
Related manuals
Manual 28 pages 23.91 Kb

ZBD5900, ZBD5600, ZBD5700 specifications

The GE ZBD5700, ZBD5600, and ZBD5900 are a trio of state-of-the-art dishwashers that exemplify the cutting-edge technology and innovative design that GE is known for. These models cater to diverse user needs while providing efficient cleaning solutions for modern kitchens.

The GE ZBD5700 stands out with its impressive capacity and advanced cleaning technologies. Equipped with a powerful wash system, this model ensures optimal water pressure and distribution, allowing for a thorough clean even on heavily soiled dishes. One of its key features is the SmartDispense Technology, which automatically dispenses the right amount of detergent based on load size and soil level. This not only enhances cleaning efficiency but also conserves detergent, making it a more eco-friendly option.

In addition, this model includes the exclusive Piranhaâ„¢ hard food disposer, which pulverizes food particles, preventing clogging and ensuring that every cycle maintains optimal cleaning performance. Furthermore, the ZBD5700 features multiple wash cycles and options, including a quick wash for lightly soiled dishes and a robust high-heat sanitize option that eliminates bacteria.

Moving to the GE ZBD5600, this dishwasher is designed with user convenience in mind. Its adjustable upper rack easily accommodates tall items, while its folding tines can be manipulated to create the necessary space in both the upper and lower racks. Infused with the latest in quiet operation technology, the ZBD5600 impressively operates at a low decibel level, making it perfect for open-concept living spaces.

The ZBD5900 offers the best of both worlds, combining sophisticated aesthetics with high-performance functionality. Its sleek design features a stainless-steel finish that not only looks elegant but is also fingerprint resistant. This model showcases advanced Dry Boost technology, which provides superior drying performance, ensuring your dishes come out spotless and ready to use.

All three dishwashers are Energy Star certified, affirming their commitment to energy efficiency. This translates to reduced utility bills and a lower environmental footprint, giving consumers peace of mind with their purchase.

In summary, the GE ZBD5700, ZBD5600, and ZBD5900 represent a significant leap forward in dishwasher technology, combining impeccable cleaning abilities with design and energy efficiency. Each model offers unique features, ensuring that there is a perfect fit for every household.