Control Panel
Dishwasher
3. Options
The light above the selected pad will be ON to indicate which option has been selected.
POWER | For use with heavily soiled and/or |
PRESOAK | MUST be selected PRIOR to starting the cycle. This option adds |
| 16 minutes to the cycle time. |
SPEED DRY | Shuts off the drying heat option. Dishes air dry naturally and energy is |
OFF | saved. You can prop the door open after the CLEAN light illuminates. |
SPEED DRY | Turns the heater on for fast drying. This cycle will extend the time ON to |
ON | your wash cycle by 23 minutes for the NORMAL cycle and 30 minutes for |
| the SANIWASH cycle. NOTE: Cannot be selected with RINSE & HOLD cycle. |
LOCK | When the LOCK pad is touched twice within 3 seconds, all pads become |
| inoperative. You can lock the controls to prevent any selections from being made. |
| Or you can lock the controls after you have started a cycle or selected DELAY |
| START so the cycle or DELAY START is not interrupted. |
| Children cannot accidentally start dishwasher by touching pads with this |
| option selected. |
| To unlock the dishwasher after it has been locked, touch the LOCK pad twice |
| within 3 seconds. The light above the LOCK pad will turn off. |
DELAY START | You can delay the start of a wash cycle for up to 8 hours. Press the DELAY |
| START pad to choose the number of hours you want to delay the start of the |
| cycle. The machine will count down and start automatically at the correct time. |
| Pressing the START/RESET button will cancel the DELAY START |
| selection. NOTE: If you forget to latch the door a reminder signal will |
| beep until you do so. |
RESET | To change a cycle after washing starts, touch the START/RESET pad |
| to cancel the cycle. After water is pumped out and the motor stops, |
| you can reprogram and restart the dishwasher. This will take |
| approximately 90 seconds. |
4. Start
Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 40 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be on and display the last settings you selected.
If you do not want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
Also, if a power failure occurs, NORMAL and SPEED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.
5. Clean
This light is illuminated when a wash cycle is complete. The light will stay on until the door is opened.
8