GE ADT520 owner manual Start Dishwasher, Cycle Completion, Steam, Prewash, Dishwasher section

		GEAppliances.com
	Select Options (Continued)
5
	Steam	For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected PRIOR to
	(Prewash)	starting the cycle. The Steam option adds approximately 30 minutes to the cycle time. This option is
	(on some models)	available with Heavy, Auto Sense, and Normal cycles.
	Wash	Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This will
	Zones	shorten the cycle time and conserve energy. This option can be used when there is only half a
	(on some models)	load of dishes.
	Delay	Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay Hours, to select
	Hours	the number of hours, then press Start one time to begin countdown. The cycle will start once allotted time
	(on some models)	has expired.
	Control	You can lock the controls to prevent selections from being made. You can also lock the controls
	Lock	after you have started a cycle to prevent cycle changes. For example, children cannot accidentally
		start the dishwasher by pressing pads with this option selected.
		To LOCK the dishwasher control, depending on the model, press and hold the Heated Dry pad for 3 seconds or
		press and hold the Steam and Wash Temp pads at the same time for 3 seconds. The Control Lock light will turn
		on to indicate the control is locked.
		To UNLOCK the dishwasher control, depending on the model, press and hold the Heated Dry pad for 3 second
		or press and hold the Steam and Wash Temp pads at the same time for 3 seconds. The Control Lock light
		will turn off to indicate the control is unlocked.
	Energy	When connected to a smart meter and your electric company, the dishwasher will automatically delay starting
	Smart	a cycle during the more expensive peak demand times, and run when demand is low. However, you can override
		the delay settings and use the dishwasher as needed. Learn more about Energy Smart under the Using the
		Dishwasher section.
	Start Dishwasher
6
	Start	Door can be open to select the desired options. Press the Start pad and close the door within 10 seconds
		to start the cycle or begin the Delay Hours countdown. The wash cycle will begin shortly after closing
		the door. If the door is open, the illuminated lights will turn off if a pad is not pressed within two minutes.
		To activate the display, close and open the door or press any pad.
	Interrupt	To interrupt or pause a dish cycle, slowly open the door. Opening the door will cause the wash cycle to
	or Pause	pause. The dishwasher will beep every minute to remind you to close the door. To restart or resume
		the cycle, press Start, and close the door.
	Cancel	To cancel a wash cycle, press and hold the Start pad for 3 seconds and close door. The dishwasher will drain,
		emit a beep sound, and the wash cycle light will turn OFF.
	Cycle Completion
7
	Sanitized	Displayed at the end of the cycle when Wash Temp Sani (Sanitize) has been selected and the dishwasher
		has met the requirements for sanitization. See Wash Temp Sani, for complete option description.
		Opening the door or pressing any key while the door is closed will turn off the light.
	Clean	Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean. Opening
		the door or pressing any key while the door is closed will turn the light off.

5