GE 49-5847-1, GSD4320, GSD4335, GSD4310, GSD4315 Dishes and flatware, Not clean, Use HI Temp Wash

Page 22

Safety Information

Instructions

Before you call for service…

Problem		Possible Causes	What To Do

Dishes and flatware		Inlet water temperature	• Raise the water heater
not clean		is below 120°F.	temperature to 120°F.
			• Use HI TEMP WASH.

		Water pressure is	• Turn on a faucet. Is water
		temporarily low	coming out more slowly
			than usual? If so, wait until
			pressure is normal before
			using your dishwasher.

		Air gap is clogged	• Clean the air gap.

		Improper rack loading	• Make sure large dishware
			does not block the
			detergent dispenser or the
			wash arm.

Operating

Troubleshooting Tips

Customer Service

Spots and filming on glasses and flatware

Extremely hard water

Low inlet water temperature

Overloading the dishwasher

Improper loading

Old or damp powder detergent

Rinse agent dispenser empty

Too little detergent

•Use Jet-Dry®rinse agent to remove spots and prevent new film build-up.

•To remove stubborn spots and pre-existing film from glassware:

1Remove all metal utensils from the dishwasher.

2Do not add detergent.

3Select the POT SCRUBBER cycle and HEATED DRY option.

4Start the dishwasher and allow to run for 18 to 22 minutes. Dishwasher will now be in the main wash.

5Open the door and pour 2 cups (500 ml) of white vinegar into the bottom of the dishwasher.

6Close the door and allow to complete the cycle.

If vinegar rinse doesn’t work: Repeat as above, except use 1/4 cup (60 ml) of citric acid crystals instead of vinegar.

22

Image 22

Contents Dishwashers GE Answer CenterCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here Safety Information GE & You Service PartnershipReview the Section on Water Heater Safety Proper Installation Maintenance Do NOT… Read and follow This Safety Information carefully When Using Your DishwasherAbout the dishwasher control panel Control SettingsCycle Selections Options StartWater Time Cycles About the dishwasher cycle sequenceCycle Sequence Cycle SequenceFlashing control panel lights START/RESET padPress the START/RESET Flashing LightsUsing the Dishwasher Door Using the dishwasherCheck the Water Temperature Use Jet-Dry Rinse AgentProper Use of Detergent Forget to Add a Dish?Upper Rack Loading the dishwasher racksWash Tower Lower Rack Silverware BasketUpper Rack-12 place setting Loading 12 and 10 place settings…Upper Rack-10 place setting Lower Rack-10 place settingAbout optional accessories Color Panels Wood Panel Trim Kit Trimless Panel KitCaring for the dishwasher Protect Against FreezingAir gap is easy to clean Does Your Dishwasher Have an Air Gap?Before you call for service… Water won’t pump Water standingBottom of the tub Out of the tubDishes and flatware Not cleanUse HI Temp Wash Black or gray Cloudiness onGlassware Marks on dishesAnd/or Heated DRY Dishes don’t drySelect HI Temp Rinse Control panelPage Page Page Page General Electric Company Consumer Product Ownership Registration GE Will Replace GE Dishwasher WarrantyWhat GE Will Not Cover In-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC