GE Built-In Dishwasher installation instructions Dishwasher WET Test, Replace Toekick, Literature

Page 12

Installation Instructions

STEP 16 DISHWASHER WET TEST

Turn on power supply (or plug power cord into outlet, if equipped).

Start the unit to check for leaks.

Press ON/OFF button to turn unit on

Press CYCLE SELECT button until light below RINSE cycle illuminates

Close door.

Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on.

Check for leaks under the dishwasher. If a leak is found, turn off power supply, then tighten connections. Restore power after leak is corrected.

Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinet. Reposition the dishwasher if necessary. See Step 9.

The dishwasher will drain and turn off about 5 to 7 minutes after the first fill. Check drain lines. If leaks are found, turn power off at the breaker and correct plumbing as necessary. Restore power after corrections are made. See Step 12.

Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged. See Step 13. Also check drain line for kinking.

Run the dishwasher through another fill and drain cycle. Check for leaks and correct if required.

At the end of drain, open door and press ON/OFF button to turn unit off.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

GE Consumer & Industrial

General Electric Company

Louisville, Kentucky 40225

ge.com

STEP 17 REPLACE TOEKICK

Use Top 4

Screw Holes

2-

Toekic

k

 

Adjust Up or Down

Figure HH

Place 2-piece toekick against the legs of the dishwasher.

Place the inner toekick piece (with slots) against the toekick bracket. The slots should align with toekick bracket screw holes. Allow the toekick to touch the floor.

Place larger toekick over the inner piece and install 4 toekick screws.

Use additional 2 screws for installations over 33-1/2" high.

Use both toekick pieces for all installation heights.

STEP 18 LITERATURE

Be sure to leave complete literature package and Installation Instructions with the consumer.

© 2005 General Electric Company

Pub. No. 31-30242

Dwg. No 206C 1559 P 180

ND 08C 2514 (4/08)

Image 12
Contents Read Carefully Keep These Instructions Read and observe all Cautions and WarningsParts Supplied Materials YOU will NeedTools YOU will Need Prepare Dishwasher Enclosure Drain RequirementsDetermine Drain Method Cabinet PreparationPrepare Electrical Wiring Grounding Instructions-Power Cord ModelsElectrical Requirements Grounding Instructions-Cable DirectPrepare HOT Water Line Check Door BalanceAdjust Leveling Legs Install Power CordInstall 90 Elbow Skip this step if dishwasher will be direct wiredInstall Drain Hose Through Cabinet Slide Dishwasher Partially Into CabinetPosition Dishwasher Under Countertop Top ViewLevel Dishwasher Drain Line Installation Connect Water SupplyConnect Drain Line Method 2 Drain Hose RoutingConnect Power Supply Pretest Check ListDishwasher WET Test Replace ToekickLiterature