Installation Instructions
STEP 9 POSITION DISHWASHER UNDER COUNTERTOP
•Push the dishwasher into the cabinet.
•Push the sides with your hands. Do not use your knee against the door since door damage will occur.
•Check that the tub insulation blanket does not get
•Center the dishwasher in the opening.
•Front of door panel should be flush with face of cabinet.
•Carefully open and close the door to ensure that the door panel does not catch or rub on the cabinet frame.
•If the door catches or rubs on the frame, reposition and/or level the unit (see Step 10) until the door moves freely and does not contact the cabinet frame.
���������������������
����������������
����������������
�������������������
���������������������
�������������������
������������������������
Figure P
The controls on these models are designed to be hidden by your countertop. Align the dishwasher as shown in Figure Q. Leave a 1/2" minimum gap between the underside of the countertop and the top of the dishwasher door as shown in Figure T.
Note: If the drain hose gets trapped behind the unit it can prevent the controls from being hidden by the countertop.
Note: If this dishwasher is replacing an existing dishwasher, the old countertop bracket screw holes may not be in the correct position to accept a
Tip: The leveling legs can be used to increase or decrease the amount of gap between the controls and the countertop affecting the visibility of the controls.
IMPORTANT – Leave a 1/2" minimum gap between the controls and the underside of the countertop to prevent condensation and damage to the control panel from screwheads.
���� |
|
�������� |
|
������ |
|
���� | ������������ |
������ | ���������������� |
������� |
|
����� |
|
| ��������� |
������� | ��������� |
��������� |
|
Figure Q |
|
Top View | |
ON | DELAY |
OFF | STARTLOW RINSE AID |
| 1 - 24 HRS. |
Controls Hidden |
|
by Countertop |
|
Figure R | Countertop |
Countertop
1/2”
Min.
Control
Panel
Figure S | Dishwasher | Figure T |
8 | Door |
|