Installation Instructions
PREPARE HOT WATER LINE
•The line may enter from either side, rear or floor within the shaded area shown in Figure F.
•The line may pass through the same hole as the electrical cable and drain hose. Or, cut an additional
CAUTION:
The hot water supply line pressure must be at least 20 psi. Lower pressures could cause the water valve to leak and cause water damage.
Valve | Hole |
| |
Hot |
|
2" |
|
From | 18" From Wall |
Cabinet |
|
| BEFORE YOU BEGIN | |
STOP | Locate and set aside the package containing | |
2 Phillips head countertop mounting screws | ||
| ||
| and 2 additional toekick screws (located in | |
| the literature package). |
STEP 1 CHECK DOOR BALANCE
To check the door balance, hold the top of the dishwasher firmly.
•Check the door balance by opening and closing the door.
•If the door drops when released, increase the spring tension. If the door rises when released, decrease the spring tension.
•Models have different spring mounting and tension methods. Refer to the appropriate figure for your model.
Increase
Decrease
Cabinet Face
Figure F
3" From Floor
Water Line Connection
•Turn off the water supply.
•Install a hand
•Water connection is on the left side of the dishwasher. Install the hot water inlet line, using no less than 3/8" O.D. copper tubing. Route the line as shown in Figure F and extend forward at least 18" from rear wall.
•Adjust water heater for 120°F to 150°F temperature.
•Flush water line to clean out debris.
•The hot water supply line pressure must be
CAUTION:
Opening the door will cause the dishwasher to tip forward. Do not open the door until you are ready
to install the dishwasher. If it is necessary to open the door, hold the top of the dishwasher securely with one hand and hold the door with the other hand.
Figure G
IncreaseIncrease
DecreaseDecrease
Figure H | PDW1800_II models only |
5