Remove Exhaust Adaptor, Remove Filter | GE 164D4290P393 instruction

Installation Instructions

2REMOVE EXHAUST ADAPTOR

If exhausting/venting using the 31⁄4″ x 10″ rectangular duct—optional for JV338, JV347 and JV367 models only:

Remove the exhaust adaptor from the inside of the hood. Set it aside along with its mounting screws.

31⁄4″ x 10″ rectangular exhaust adaptor

and screws

3REMOVE FILTER

Remove the shipping tape holding the metal grease filter in place. Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back.

Metal grease filter

4REVERSE THE BAFFLE FOR

DUCTED INSTALLATIONS ONLY

(JV347 and JV367 models)

If the hood is to be recirculated, skip to the next step. Remove the baffle from the top of the hood. Re-install the baffle so the short side marked “VENTED” is visible. The long side of the baffle should be inside the hood.

“VENTED” is visible

5REMOVE WIRING COVER

Remove the wiring cover from inside the hood. Set the cover and its mounting screw aside.

Wiring cover

6REMOVE WIRING KNOCKOUT

Remove either the top or the back wiring knockout as needed and install an approved strain relief clamp.

Back knockout
Top knockout
Strain relief	Strain relief
clamp	clamp