Maytag MFI2067AEW installation instructions Water and Ice Dispenser, Dispense Ice and Water

Page 11

Ice Maker and Ice Storage Bin

The ice maker and storage bin are located in the upper left-hand side of the refrigerator compartment.

Turning the Ice Maker On/Off

The On/Off switch is located on the ice maker.

To turn on the ice maker, press the switch to the ON position.

To manually turn off the ice maker, press the switch to the OFF position.

NOTE: Your ice maker has an automatic shutoff. The ice maker sensors will automatically stop ice production, but the control will remain in the ON position.

Removing and Replacing Ice Storage Bin

To Remove the Ice Storage Bin:

1.Hold the base of the storage bin and press the release button on the lower right.

2.Pull the storage bin out until resistance is felt. Lift up the front of the ice bin and remove.

3.Press the switch to the OFF position

To Replace the Ice Storage Bin:

IMPORTANT: It may be necessary to turn the auger driver, behind the ice bin, counterclockwise to properly align the ice bin with the auger driver. The ice storage bin must be locked in place for proper ice dispensing.

1.Press the switch to the ON position

2.Slide the ice bin into the guide rails located on either side of the enclosure.

3.Push the ice bin in until resistance is felt. Raise the front slightly and push the ice bin in until an audible “click” is heard.

A

Remember

The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.

Do not use anything sharp to break up the ice in the bin. This can cause damage to the ice bin and dispenser mechanism.

Do not store anything on top of the ice maker or in the ice storage bin.

Water and Ice Dispenser

IMPORTANT:

After connecting the refrigerator to a water source, flush the water system. Press the Water button on the dispenser control panel. Use a sturdy container to depress and hold the dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever

(5 seconds on, 5 seconds off) for an additional 2 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.

NOTE: After 5 minutes of continuous dispensing, the dispenser will stop dispensing water to avoid flooding. To continue dispensing, remove the container and press the dispensing lever again.

Allow 24 hours for the refrigerator to cool down and chill water. Dispense enough water every week to maintain a fresh supply.

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

B

A. ON position

B. Auger driver

Ice Production Rate

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

The ice maker should produce approximately 8 to 12 batches of ice in a 24-hour period.

To increase ice production, lower the freezer and refrigerator temperature. See “Using the Controls.” Wait 24 hours between adjustments.

Dispense Ice and Water

WARNING

Cut Hazard

Use a sturdy glass when dispensing ice.

Failure to do so can result in cuts.

1.Select water or cubed ice by pressing the corresponding button on the dispenser control panel. A light above the button indicates your selection.

11

Image 11 Contents
Refrigerator User Instructions Refrigerator SafetyBefore You Throw Away Your Old Refrigerator or Freezer Installation InstructionsClean Before Using Unpack the RefrigeratorRecommended Grounding Method Location RequirementsElectrical Requirements Water Supply RequirementsConnect to Water Line Connect the Water SupplyWater Pressure Reverse Osmosis Water SupplyStyle 2 Plastic Handles Complete the InstallationRefrigerator Doors and Drawer Remove and Replace Handles Style 1 Metal HandlesReplace Drawer Front Replace Doors and HingesRemove and Replace Freezer Drawer Remove Drawer FrontDrawer Front Removal Drawer Front Replacement Style 1 Front and rear leveling Adjust the Doors Refrigerator USE Opening and Closing DoorsUsing the Controls Crisper Humidity Control Dispense Ice and Water Water and Ice DispenserWater Filtration System CleaningRefrigerator Care Refrigerator will not operate TroubleshootingChanging the Light Bulb Refrigerator OperationIce and Water Temperature and MoistureWater is leaking from the dispenser system Water Filter CertificationsOff-taste, odor or gray color in the ice Water and ice dispenser will not operate properlyApplication Guidelines/Water Supply Parameters Product Data SheetsThis limited warranty does not cover Maytag Major Appliance WarrantyLimited Warranty Items Excluded from WarrantySécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurDéballage du réfrigérateur Instructions D’INSTALLATIONExigences demplacement Pression de leau Méthode recommandée de mise à la terreSpécifications électriques Spécifications de l’alimentation en eauRaccordement au réfrigérateur Raccordement de la canalisation deauRaccordement à une canalisation d’eau Enlèvement de la porte et des charnières Achever l’installationPortes et tiroir du réfrigérateur Style 2 Poignées en plastiqueEnlèvement de la façade du tiroir Réinstallation des portes et des charnièresRetirer et réinstaller le tiroir du congélateur Réinstallation de la façade du tiroirEnlèvement et réinstallation de la porte Style 1-Nivellement avant et arrière Utilisation DU RéfrigérateurAjustement des portes Ouverture et fermeture des portesPour ajuster les réglages de température Utilisation des commandesCommandes de température Ajustement des commandesTemp Alarm alarme de dépassement de température Humidity Control commande dhumidité sur certains modèlesDoor Alarm avertisseur de la porte Vacation Mode mode vacances sur certains modèlesTaux de production de glaçons Pour réinstaller le bac d’entreposage à glaçonsDistributeur d’eau et de glaçons Mise en marche/arrêt de la machine à glaçonsSystème de filtration de leau Nettoyage de votre réfrigérateur Remplacement de l’ampoule d’éclairageEntretien DU Réfrigérateur NettoyageFonctionnement du réfrigérateur DépannageGlaçons et eau Température et humiditéLeau du distributeur est tiède ’eau coule du système de distributionSystème de filtration d’eau intérieur Feuilles DE Données SUR LE ProduitLa présente garantie limitée ne couvre pas Garantie LimitéeArticles Exclus DE LA Garantie Tous droits réservés W10175444A SP PN W10175477A