Fisher & Paykel DW920, DW820 Changing the pre-set options, End of programme beeps

Page 18

Changing the pre-set options

End of programme beeps

The beeps at the end of each wash programme can be removed by following the steps below.

1Press the POWER button to turn the Dishwasher off.

2Press the ECO button and while holding down, press the START/PAUSE button and hold together for approximately five seconds until you hear one short beep.

3Release the two buttons and the “beeps” are now removed.

If you wish to re-instate the beeps at the end of the wash programmes, repeat the steps above.

Image 18

Contents Dishwasher Page Contents Installation instructions Before you startPlumbing Built-In Installation InstallationTo Change the Setup for a hot or cold water supply LevellingElectrical Joinery dimensions DW820 & DW920Specifications Product SizeDiagram 1 Dishwasher Diagram 2 Dishwasher & waste disposal unitPlumbing and drainage options Introduction AccessoriesSafety instructions First useQuick operating instructions START/PAUSE button Power ButtonControl panel OffWash button Eco buttonTime remaining display 920 Model Only Loading the dishwasher Upper basketLower basket Cutlery basket Detergent Detergent usageFilling the detergent dispenser Drying Rinse aidHow much rinse aid? To fill the dispenserWash programmes Changing the pre-set options End of programme beepsAustralian/New Zealand standards AS2007.1 Loading patternsDetergent quantities Care guide Cleaning the dishwasher Care and cleaningCleaning the strainer Cleaning the spray armsProblem solving Problem Possible cause What to doWater spots, streaks or Fault codes Model onlyManufacturer’s warranty This warranty does not coverFisher & Paykel undertakes to New Zealand If you need assistance If you need serviceCustomer care Australia If you need assistance callPage Suburb Product detailsModel/Serial No Country