Cleaning the spray arm and filter plate

Ensure the DishDrawer® is cool before you start cleaning and follow the instructions for removing the drain filter and spray arm.

1	Remove the basket carefully. Lift from the back		1
	end first to prevent knocking the detergent		1
	and rinse agent dispenser.
2	Lift the spray arm and shake any foreign material
	out.
	Rinse the spray arm clean under running water
	and wipe with a damp cloth.	2
3	In the center of the filter plate there are two rings.	2	1
3	In the center of the filter plate there are two rings.		1
	Hold the center ring still and turn the outer ring	3
	counter-clockwise, about a 1/8 turn. This will	3	4
	release the filter plate.		4
4	Lift the filter plate out.
	When cleaning the underside of the filter plate,
	take care handling the sharp outer edge to avoid
	the risk of cuts.
	Remove any foreign material, wash in hot soapy	a
	water and rinse thoroughly in clean water. The	a
	water and rinse thoroughly in clean water. The
	heater plate can be wiped with a damp cloth.
5	Replace the filter plate so it lies flat in the base of
	the drawer ensuring the filter plate is fully locked	b
	into position with the center ring.	b
6	To lock the filter plate into position, ensure the
	lines align with each other (refer to the diagram	c
	for the correct position). The filter plate must not
	be able to move about freely.
7	Replace the spray arm back onto the impeller.	d
		d

8Replace the basket, lowering the front edge of the

basket into position first.	Correct locking position of filter
	plate with motor assembly
Note: Where there is broken crockery or glass in the	(under spray arm)
	a	Outer ring
drawer, it must be carefully removed to prevent
	b	Impeller
damage to the DishDrawer®.
	c	Correct alignment marks
	d	Center ring

US CA