Samsung DMT800DD6800050A Water supplied is soft and too, Remove the marks on the dishes using a

troubleshooting

PROBLEM	POSSIBLE CAUSE	SOLUTION
	The water supplied is soft and too	Underload the dishwasher and use a rinse
Leaves glasses with	much detergent was used.	aid to minimize this.
a dim polish.	Aluminum dishes were included in	Remove the marks on the dishes using a
	the wash load.	low sensitivity cleaner.
Leaves a yellow	This is caused by coffee and tea	Remove the soils using a spot cleaner.
or brown film on	soils.
the inside of the
dishwasher.
	There is no rinse aid in the	Check the dispenser and add the rinse aid.
	dispenser.	Use a liquid type rinse aid.
	The temperature of the water	Connect the water supply line to a hot
	is low when the dishwasher is	water supply.
	running.	Use rinse aid with the Sanitize option.
Does not dry dishes
	Too many dishes have been	Proper loading of items can affect drying.
well.	loaded.	Load your dishes as recommended. (See
		page 16.)
	Glasses and cups with concave	After finishing the cycle, empty the lower
	bottoms hold water. This water	rack first and then the upper rack, this will
	may spill onto other items when	avoid water dripping from the upper rack
	unloading.	onto the dishes in the lower rack.
	There is water left over when the	Insert detergent without loading dishes,
	last cycle is not completed.	and run the Normal cycle to clean the
		dishwasher.
	Drain Hose is obstructed.	Contact a qualified service technician to
		remove any obstruction from the drain
Has a bad odor.		hose.
	The dishwasher is not used daily	With the dishwasher empty and no
	or Soiled dishes left in unit too	detergent, place a glass with 8
	long.	ounces of vinegar upright into the lower
		rack, and then run a Normal
		cycle.
	Sound is generated when the	This is normal operation.
	dispenser cover is open and the
	drain pump is operating in an early
	stage.
	The dishwasher is not level.	Ensure the dishwasher is level.
Is too noisy.
	Foreign material (Screw, Plastic	Contact a qualified service technician to
	piece) is in pump chamber.	remove foreign material from the pump
		chamber.
	There is a ‘chopping’ sound	Rearrange the dishes.
	because a nozzle is bumping
	against the dishes.

24_ troubleshooting