Fisher & Paykel WD1001 manual

3.Slide the waste pipe flange on to the waste pipe.

4.Attach the rubber gasket to the waste pipe so that the thin lip is facing the disposer. (ILLUSTRATION #14)

5.Insert the non-notched end of the waste pipe flange into the slot below the waste outlet on the waste disposer. (ILLUSTRATION #15)

6.Use the screw to tighten the waste pipe to the disposer.

7.Rotate the disposer so that the waste pipe lines up with the drain trap. (ILLUSTRATION #16).

8.Once the waste pipe is lined up use a pipe wrench to tighten the slip nut on the drain trap. ILLUSTRATION #17).

9.If fitted to a double sink, the use of separate traps for the disposer and the sink are recommended.

10.Make sure that the hinged clamp is locked firmly in place.

- 7 -

ILLUSTRATION #14

ILLUSTRATION #15

ILLUSTRATION #16

ILLUSTRATION #17