troubleshooting
PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
| The water temperature was low. | For best performance, the | |
|
| temperature of the supplied water | |
|
| should be 120 ˚F (49 ˚C). | |
|
|
| |
| The amount of detergent was | Use the appropriate amount of | |
| inappropriate. | automatic dishwasher detergent. | |
|
|
| |
| Too many dishes have been loaded. | Load only an appropriate number of | |
|
| dishes. | |
|
|
| |
There are spots and film | The dishes were loaded incorrectly. | Load your dishes as recommended. | |
| (See page 16.) | ||
left on dishes. |
| ||
|
| ||
Low water pressure. | The water pressure should be | ||
| |||
|
| between 20 and 120 psi (140 ~ 830 | |
|
| kPa). | |
|
|
| |
| Improper detergent was used. | Use automatic dishwasher | |
|
| detergent. | |
|
|
| |
| There is no rinse aid. | Check the dispenser and add rinse | |
|
| aid. | |
|
|
| |
| The water is too hard. | Add a water softener. | |
|
|
| |
| Sound is generated when the | This is normal operation. | |
| dispenser cover is open. |
| |
| Sound is generated when the drain |
| |
| pump is operating in an early stage. |
| |
|
|
| |
| The dishwasher is not level. | Ensure the dishwasher is level. | |
Is too noisy. |
|
| |
Foreign material (screw, plastic | Contact a qualified service technician | ||
| |||
| piece, etc.) is in the pump chamber. | to remove foreign material from the | |
|
| pump chamber. | |
|
|
| |
| There is a ‘chopping’ sound because | Rearrange the dishes. | |
| a nozzle is bumping against the |
| |
| dishes. |
| |
|
|
| |
| The water supplied is soft and too | Underload the dishwasher and use a | |
Leaves glasses with a | much detergent was used. | rinse aid to minimize this. | |
dim polish. | Aluminum dishes were included in | Remove the marks on the dishes | |
| the wash load. | using a low sensitivity cleaner. | |
|
|
| |
Leaves a yellow or brown | This is caused by coffee and tea | Remove the soils using a spot | |
film on the inside of the | soils. | cleaner. | |
dishwasher. |
|
| |
|
|
| |
Does not have any lights | The power is not connected. | Connect the power cable. | |
|
| ||
lit up. | The circuit breaker has failed. | Check the circuit breaker. | |
|
|
| |
Does not have a | The nozzle hole is clogged with food | Clean the nozzle hole. | |
smoothly rotating nozzle. | particles. |
| |
|
|
| |
Has a bent upper rack | The dishes are not loaded properly. | Load your dishes as recommended. | |
after loading dishes. |
| (See page 16.) | |
|
|
|
24_ troubleshooting