Collar Trim Installation

TNX22BRCWW - GE Profile Performance™ 21.7 Cu. Ft. CustomStyle™ No-Frost Top-Freezer Refrigerator with Dispenser

8' Ceiling

12" Soffit

13" to 14" Cabinet

Refrigerator

Case

Magnetic

Tape

Door Gasket

3/4" Cabinet

Side Panel

1/2" Cabinet

Side Panel

Side Trim

Side trim must be installed flush with the gasket contact surface on the case.

Overhead	Cabinet
Cabinet	Door
	1"
Case
	Top
	Trim

70-1/4"*

24-1/2"

An enclosure is required to match up to the trim, see Typical Installation. To obtain the most integrated look, the cabinet or soffit above the refrigerator should extend out to the same depth as the side panels. The refrigerator opening must have minimum dimensions of 70-1/4" high x 36-1/8" wide x 24-1/2" deep as shown at right. If there is an overhead cabinet, allow 1" for cabinet door clearance with the top trim piece so the cabinet doors can be opened without hitting the top trim. If 1/2" side panels are used, then side trim and panel will be even. If 3/4" side panels are used, then some of the side panel will extend beyond the trim and must be finished.

36-1/8"

*The rough-in dimension of 70-1/4" is minimum and is measured from the finished floor to top of opening (or the underside of the overhead cabinets).

For Models with Trim Kit: If frameless style cabinets are planned for above the refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to height of opening to allow addi- tional clearance between cabinet doors and top of refrigerator trim when cabinet doors are in open position.

Specification Revised 10/99

VOLUME and

SHELF AREA

Manufacturer Certified to

ASSOCIATION OF HOME

APPLIANCE MANUFACTURERS

ANSI/AHAN HRF-1-1979

Total volume and shelf area are calculated by the Association of Home Appliance Manufacturers’ standards.

Listed by

Underwriters

Laboratories

For answers to your Monogram,® GE Profile Performance Series,™

GE Profile™ or GE appliance questions, call GE Answer Center® service, 800.626.2000.