GE TMW-1100EC, TMW-800TC, TMW-1100MC manual Installation, Leave space behind and side

Page 10

INSTALLATION

1. Steady, flat location.

This microwave oven should be set on a steady, flat surface.

2. Leave space behind and side.

All air vents should be kept clear. If all vents are covered during operation, the oven may be overheated and, eventually, cause oven failure.

3. Away from radio, and TV sets

Poor television reception and radio interference may result if the oven is located close to a TV, radio, antenna, or feeder and so on. Position the oven as far from them as possible.

4. Away from heating appliances and water taps

Keep the oven away from hot air, steam or splash when choosing a place to position it, or the insulation might be adversely affected and breakdowns occur.

5.Power supply

Check your local power source.

This microwave oven requires a current of approximately 14.5 amperes, 120Volts, 60Hz grounded outlet.

1.A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or trippping over a longer cord.

2.Longer cord sets or extension cords are available and may be used if care is exercised in their use.

3.If a long cord or extension cord is used:

1)The marked electrical rating of the cord set or extension cord should be at least as great as the electrical rating of the appliance.

2)The extension cord must be a grounding type 3-wire cord.

3)The longer cord should be arranged so that it will not drape over the counter top or tabletop where it can be pulled on by children or tripped over unintentionally.

6. Examine the oven after unpacking for any damage such as:

A misaligned door, broken door or a dent in cavity.

If any of the above are visible, DO NOT INSTALL, and notify dealer immediately.

8

Image 10
Contents Turbo Air Inc Microwave Oven Table of Contents TMW-800T / TMW-800TC For Safe Operation Safety and PrecautionsFor Safe Service Procedures Microwave RadiationSpecifications Safety interlock system Outer Dimension Feature Diagram External View ElectricalControl Panel External View Mechanical 560 483 344Installation Leave space behind and sideWattage output chart Operations and Functions ElectricalVariable power setting Approximate Percentage Variable power cookingOperations and Functions Mechanical Disassembly and Assembly ShortTo remove cabinet Part Code Part Name Description To reduce gap located on part ‘A’ REF no Part Code Part Name Description ’TY Remark Part Code Part Name Description ’TY Magnetron To remove wind guide assembly Adjustment Primary interlock switchSecondary interlock switch and interlock monitor switch Adjustment stepsCheck Result Trouble Shooting GuideCondition CauseCheck Condition Check Result Cause RemedyCondition Check Result Relay RY1Not show Interlock Mechanism and Adjustmentmechanical No Continuity Replace power supply cord YES Heating time for power output ProcedureMeasurement and Test Microwave Radiation Test High voltage diode High voltage transformerHigh voltage capacitor MagnetronWiring Diagram TMW-1100EC Wiring Diagram TMW-1100E Wiring Diagram TMW-1100MC Wiring Diagram TMW-1100M Voltage Check Printed Circuit BoardLow voltage transformer check Check Point RemarkMP1 MP2 Measure pointGND 12VDC Point State Relay 2 on 5VDC GND Relay 2 OFF 12VDCPoint State Relay 1 on 5VDC GND Point StateC.B. Circuit Diagram C.B. Location no Name Symbol Specification Part Code ’TY Exploded View and Parts List Electrical Total AssemblyPart Code Part Name Description QTY Exploded View and Parts List Mechanical CONTROL-PANEL AS KOR-1P55BA Power Consumption Grill Combination Microwave Energy Output Power SupplyTMW-800T / TMW-800TC Outer Dimension Feature Diagram External ViewSteady, flat location Operations and Functions Disassembly and Assembly REF no Part Code Part Name Description ’TY Page Knob VPC Knob TimerCoupler Timer POM Coupler VPC Knob POMHigh voltage circuit wiring To remove magnetron Noise FilterOnly KOR-63555B Interlock Mechanism and Adjustment Trouble Shooting Guide Does the oven lamp light? no Does the turntable turn? Measurement of the Microwave Power Output Procedures Microwave Radiation TestComponent Test Procedure Wiring Diagram TMW-800TC Wiring Diagram TMW-800T Power Supply Single Phase onlyExploded View and Parts List Total AssemblyCabinet Secc T0.5 Door ASControl Panel AS Cavity ASAbout this Manual