GE 42 About the water filter. on some models, Water Filter Cartridge, When to Replace the Filter

Page 6

About the water filter. (on some models)

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

Cartridge

Holder

Place the top of the cartridge up inside the cartridge holder and slowly turn it clockwise.

Filter

Bypass

Plug

Water Filter Cartridge

The water filter cartridge is located in the top grille compartment. Flip up the panel top grille to access the water filter.

When to Replace the Filter

There is a replacement indicator light for the water filter cartridge on the dispenser. This light will turn orange to tell you that you need to replace the filter soon.

The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases.

Installing the Filter Cartridge

The filter cartridge is designed to filter

500 gallons of water (lasting approximately

12 months).

If you are replacing the cartridge, first remove the old one by slowly turning it counterclockwise. Do not pull down on the cartridge. A small amount of water may drip down.

Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation.

Lining up the arrow on the cartridge and the cartridge holder, place the top of the new cartridge up inside the holder. Do not push it up into the holder.

Slowly turn it clockwise until the filter cartridge stops. DO NOT OVERTIGHTEN. As you turn the cartridge, it will automatically raise itself into position. Cartridge will rotate about 1/4 turn.

Run water from the dispenser for

3 minutes (about 112 gallons) to clear the system and prevent sputtering.

Press and hold the RESET WATER FILTER button on the dispenser for 3 seconds.

NOTE: A newly-installed water filter cartridge may cause water to spurt from the dispenser.

Filter Bypass Plug

You must use the filter bypass plug

when a replacement filter cartridge is not available. The bypass plug will be taped to the door bin in the new unit.

NOTE: The dispenser and the icemaker will not operate without the filter or filter bypass plug.

Replacement Filters:

To order additional filter cartridges

in the United States, visit our Website, GEAppliances.com, or call

GE Parts and Accessories, 800.626.2002.

GWF

Suggested Retail $34.95 USD

Customers in Canada should consult the yellow pages for the nearest Camco Service Center.

6

Image 6
Contents 49-60341-1 11-04 JR Serial #Safety Precautions Before You Throw Away Your Old Refrigerator or Freezer RefrigerantsGEAppliances.com HOW to Connect Electricity Performance Air Flow System About the water filter. on some models When to Replace the FilterInstalling the Filter Cartridge Water Filter CartridgeSpillproof Shelves and Freezer Shelves About the shelves and binsRefrigerator Door Bins and Freezer Door Bins To remove shelvesAbout the refrigerator doors Refrigerator DoorsDoor Alignment About the drawers and baskets Adjustable Humidity DrawersHow to Remove and Replace the Drawers and Freezer Baskets Fruit and Vegetable DrawersAbout the ice and water dispenser and automatic icemaker Ice Storage BinAutomatic Icemaker To Use the Dispenser Door AlarmAbout the ice and water dispenser Locking the Dispenser Quick IceCare and cleaning of the refrigerator Cleaning the OutsideCleaning the Inside Preparing for Vacation Preparing to MoveRefrigerator Compartment-Lower Light Replacing the light bulbsRefrigerator Compartment-Upper Light Freezer CompartmentBefore YOU Begin Read Carefully Keep These InstructionsRead these instructions completely and carefully Hardware Supplied Materials RequiredTools Required Water and Electrical Locations Installation Space Dimensions and ClearancesAdditional Specifications Cutout depth must be 24″Top View Door Swing Factory setting Scale Top View Customization Basics ″ Framed Panel Dimensions Important Note Dispenser Trim″ Framed Custom Panel Option ″ FULL-WIDTH Overlay Custom Panel Option″ Framed Custom Wood Panels Fresh Food PanelGrille Panel Upper Freezer PanelLower Freezer Panel ″ FULL-WIDTH Overlay Custom Panels Finished Backer PanelLower Freezer Panel Spacer Assembly Flooring Side PanelsGrounding the Refrigerator IMPORTANT-Please read carefullyRemove Packaging Install Water Line Shut off the main water supply2A Water Line Installation with a Reverse Osmosis System Install Side PanelsInstall ANTI-TIP Brackets Connect Power Level RefrigeratorAdjust Door Swing Install Grille PanelRefrigerator must be secured to prevent tipping Install Door Panels Reinstall Handles Install Door PanelsInstall 1/4″ Decorative Panels Remove Handles ″ Custom Decorative PanelsCopper Tubing Turn on the PowerConnect Water Supply GE SmartConnect TubingInstall Toekick Start IcemakerDoor Alignment Normal operating sounds Hummm WhooshTroubleshooting tips… Slow ice cube freezing See Care and cleaningSmall or hollow cubes Water dispenser doesFreezer Refrigerator has odor Temperatures are OKOrange glow Moisture forms onConsumer Warranty GE Will Replace What GE Will Not CoverGeneral Installation/Operation/Maintenance Requirements Performance Data SheetOperating Specifications Special NoticesWater Treatment Device Certificate Number Operating Instructions Safety Instructions We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Fonctionnement Avertissement RéfrigérantsRaccordement Électrique Electromenagersge.caLes commandes de température Système de circulation d’airFiltres de remplacement Remplacement du filtreInstallation de la cartouche du filtre à eau Cartouche du filtre à eauPour enlever un bac Soulevez le bac vers Clayettes et bacsClayettes anti-déversements et clayettes de congélateur Enlèvement des clayettesLes portes du réfrigérateur Portes du réfrigérateurAlignement des portes Les tiroirs et les paniers Tiroirs à fruits et légumesTiroirs avec humidité variable Pour enlever Bac à glaçonsMachine à glaçons automatique Pour remettre en placeGlace rapide Le distributeur d’eau et de glaçonsPour utiliser le distributeur Verrouillage du distributeurEntretien et nettoyage du réfrigérateur Nettoyage de l’extérieurNettoyage de l’intérieur Départ en vacances DéménagementCompartiment réfrigérateur-lampe inférieure Remplacement des ampoulesCompartiment réfrigérateur-lampe supérieure Compartiment congélateurAvant DE Commencer Lire ces instructions complètement et soigneusementQuincaillerie Fournie Matériel NécessaireOutils Nécessaires Espace Pour L’INSTALLATION Dimensions ET Espaces LibresPanneau de soutien De 19 mm 3/4 po Éléments DE Personnalisation Dimensions DES Panneaux Encadrés DE 6 mm 1/4 po Option DE Panneau Personnalisé Encadré DE 19 MM Panneaux DE Bois Personnalisés Encadrés DE 19 MM Panneau de Compartiment pourAliments frais Panneau de grille Panneau supérieur pour le congélateurPanneau inférieur pour le congélateur Panneaux Personnalisés Couvrants Pleine Largeur DE 19 MM Panneau de compartiment pour aliments fraisPanneau inférieur pour le congélateur SOL Panneaux LatérauxMise À LA Terre DU Réfrigérateur IMPORTANT-À lire attentivementEnlèvement DE L’EMBALLAGE Plat SUR LE SOL Pour Enlever LA PaletteInstallation DE LA Conduite D’EAU Coupez l’alimentation d’eau principaleInstallez Panneaux Latéraux Installez PattesANTI-BASCULEMENT Mise EN Place Dans L’ESPACE D’INSTALLATION Branchement DE ’ALIMENTATION ÉlectriqueMise À Niveau DU Réfrigérateur Installation DU Panneau DE LA Grille Fixation DU Réfrigérateur AUX ArmoiresRepose des poignées Panneaux décoratifs sur mesure de 19 mm 3/4 poBranchement DE ’ALIMENTATION D’EAU Mise Sous TensionInstallation DE LA Plinthe Mise EN Marche DE LA Machine À GlaçonsAlignment DES Portes Bruits normaux de fonctionnement HummmConseils de dépannage… Bourdonnement La machine à glaçonsNe fonctionne pas FréquentLe distributeur d’eau Consultez Installation de la conduite d’eauConsultez Remplacement des ampoules Fonctionne, mais neLes températures sont Un signal sonore’arrête jamais mais NormalesGarantie DU Client Feuillet de données relatives à la performance Norme no 42 Effets esthétiquesPage Page Page Service de réparations Prolongation de garantieInscrivez votre appareil électroménager Schedule Service Consumer Support
Related manuals
Manual 16 pages 56.45 Kb

48, 42 specifications

The GE 42 and GE 48 are two state-of-the-art aircraft engines produced by General Electric, renowned within the aerospace sector for their advanced technologies and high-efficiency performance. These engines, designed primarily for commercial and military aviation, exemplify GE's commitment to innovation in the world of jet propulsion.

One of the distinguishing features of the GE 42 is its high bypass ratio, which allows for reduced fuel consumption and lower emissions during operation. This characteristic directly contributes to the engine's environmental efficiency, making it a favorite among airlines looking to minimize their carbon footprint while maximizing fuel economy. The GE 42 is equipped with advanced composite fan blades and fan cases, which contribute to its robust performance while maintaining a lightweight structure.

On the other hand, the GE 48 boasts similar high bypass ratio features but comes with slightly enhanced performance metrics suitable for larger aircraft. The GE 48 utilizes cutting-edge digital technologies, including predictive maintenance systems, enabling real-time monitoring of engine performance. This capability allows operators to make informed decisions about maintenance schedules and operational efficiency.

Both engines employ the latest in additive manufacturing, allowing for complex parts to be produced with a high degree of precision and reduced waste. This not only enhances performance but also lowers production costs, ensuring that GE remains competitive in the market. Additionally, both the GE 42 and GE 48 feature improved aerodynamics, with specially designed turbine blades that optimize airflow, thereby boosting overall efficiency.

The durability of these engines is another notable highlight. They are designed to withstand extreme operational conditions, ensuring reliability whether used for long-haul flights or military missions. Engine life extends through advanced materials that can endure high temperatures and stresses, making them suitable for various applications.

In conclusion, the GE 42 and GE 48 stand out in the aviation industry for their innovative technologies and characteristics. Their high bypass ratios, use of advanced materials, digital monitoring systems, and aerodynamic designs make them exemplary choices for modern aviation needs, catering to both commercial and military sectors while focusing on sustainability and performance. As aviation technology continues to evolve, these engines remain at the forefront, embodying the future of flight.