About the water filter. (on some models) | ge.com |
On some models |
|
Water Filter Cartridge | Slowly turn it to the right until the filter cartridge stops. |
The water filter cartridge is located in the back upper right | DO NOT OVERTIGHTEN. As you turn the cartridge, it will |
corner of the refrigerator compartment. | automatically raise itself into position. The cartridge will |
| move about 1/2 turn. |
Safety Instructions
When to Replace the Filter on Models With a Replacement Indicator Light
There is a replacement indicator light for the water filter cartridge on the dispenser. This light will turn orange to tell you that you need to replace the filter soon.
The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases.
When to Replace the Filter on Models Without a Replacement Indicator Light
The filter cartridge should be replaced every six months or earlier if the flow of water to the water dispenser or icemaker decreases.
Removing the Filter Cartridge
If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down.
Installing the Filter Cartridge
If you are replacing a SmartWater cartridge with
an adapter, it must be removed before installing the cartridge. To remove the adapter, turn it to the left about 1/4 turn.
If you are replacing a Water by Culligan cartridge, leave the adapter in place. This adapter will stay in the refrigerator when you replace future cartridges.
Cartridge
Holder
Run water from the dispenser for 3 minutes (about
Press and hold the WATER FILTER pad (on some models) on the dispenser for 3 seconds.
NOTE: A
Filter Bypass Plug
You must use the filter bypass plug when a replacement filter cartridge is not available. The dispenser and the icemaker will not operate without the filter or filter bypass plug.
Operating Instructions Installation Instructions
|
|
| Without adapter |
|
|
| |
With adapter |
| ||
| |||
| |||
(appearance may vary)
On models without a replacement indicator light, apply the month and year sticker to the new cartridge to remind you to replace the filter in six months.
Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation.
Line up the arrow on the cartridge and the cartridge holder. Place the top of the new cartridge up inside the holder. Do not push it up into the holder.
Filter | Filter |
Bypass | Bypass |
Plug | Plug |
SmartWater | Water by Culligan |
To use the filter bypass plug on Water by Culligan models, you must first remove the filter adapter from the cartridge holder by turning it to the left.
If you have
or call 1.800.GE.CARES (1.800.432.2737).
Replacement filters:
To order additional filter cartridges in the United States,
visit our Website at ge.com, or call GE Parts and Accessories, 800.626.2002.
MWF
Suggested Retail
Customers in Canada should consult the yellow pages | 7 |
for the nearest Camco Service Center. |
Troubleshooting Tips Consumer Support